Abstract:The proton exchange membrane fuel cell （PEMFC） must ensure sufficient hydration of the proton exchange membrane during operation， and it must also avoid condensed liquid water blocking the mass transfer channel. In order to analyze the effect of cathode relative humidity on the membrane water content and output performance of proton exchange membrane fuel cells， the cathode inlet water content （CIWC） model was established. Firstly， the influence of membrane resistance by temperature and water content is considered in this model， the water content calculation formula of the membrane is derived， and the CIWC model is coupled to the computational fluid dynamics software Fluent for calculation. Secondly， a fuel cell test bench was built to conduct experiments when the operating temperature was 60 °C， the relative humidity of the anode was 100%， and the relative humidity of the cathode was 50%， 75% and 100%， respectively. Finally， the simulated data of CIWC model and Fluent built-in model are compared with the experimental values， and the species distribution of membrane water content， membrane conductivity， and molar fraction of water in the catalytic layer were analyzed on the cathode side. The results show that when the cathode relative humidity is 50%， the accuracy of the CIWC model is improved by 17.67% compared to the Fluent model at a voltage of 0.739 V. The maximum relative error between the CIWC model and the experimental value is 5.66% at 100% cathode relative humidity. With the increase of the relative humidity of the cathode， the membrane water content increases continuously at a voltage of 0.75 V and tends to be saturated at a voltage of 0.6 V， and the membrane water content， the proton conductivity and the molar fraction of the water in the catalytic layer gradually increase in the direction of the flow field from the air inlet to the outlet. When the cathode relative humidity is 75%， the fuel cell output power density is up to 272.08 mW/cm 2 ， and the distribution of membrane water content is more uniform.

A parametric study on water transfer in a PEMFC

Study on Net Water Transfer of PEMFC

Numerical studies of liquid water behaviors in PEM fuel cell cathode considering transport across different porous layers

Effect of cathode relative humidity on membrane water content and performance of PEMFC

Uncoupling Characteristics Of Temperature And Relative Humidity Distribution In A Commercial-Size Polymer Electrolyte Membrane Fuel Cell

Investigating temperature-driven water transport in cathode gas diffusion media of PEMFC with a non-isothermal, two-phase model

Numerical simulation and experimental study on the effect of cathode relative humidity on the performance of the PEMFC with dead-ended anode

Numerical Study of Water Transport and Operating Strategy for Fuel Cells with Segmented Water Management Flow Fields

Numerical Modeling and Performance Prediction of Water Transport for PEM Fuel Cell

NUMERICAL INVESTIGATION OF THE COUPLED WATER AND THERMAL MANAGEMENT IN PEM FUEL CELL

Comparison of Self-Humidification Effect on Polymer Electrolyte Membrane Fuel Cell with Anodic and Cathodic Exhaust Gas Recirculation

Experimental and Modeling Study on Water Dynamic Transport of the Proton Exchange Membrane Fuel Cell under Transient Air Flow and Load Change

Performance of PEMFCs with Internal Humidification

Design and multi-objective optimization of low-temperature proton exchange membrane fuel cells with efficient water recovery and high electrochemical performance

Modeling and Experimental Investigation of the Anode Inlet Relative Humidity Effect on a PEM Fuel Cell

Distribution Characteristics and Control Optimization of Anode and Cathode Water in Fuel Cells under Low Humidification

The Effect of Operating Parameters on Water Transport in Pem Fuel Cells

Numerical and Experimental Investigation of the Asymmetric Humidification and Dynamic Temperature in Proton Exchange Membrane Fuel Cell

Analyze the Effects of Flow Mode and Humidity on PEMFC Performance by Equivalent Membrane Conductivity

Water transport model for cathode of PEMFC

Effects of Humidification Temperatures on Local Current Characteristics in a PEM Fuel Cell