Abstract:In order to study the flow characteristics of a nozzle with large expansion ratio and its influence on the force on the nozzle, ground cold flow test research and a fluid–structure coupling simulation analysis were carried out (maximum expansion ratio ε = 30.25). The variation and pulsation characteristics of the pressure near the measuring point area and the inlet pressure were obtained through experiments. Through the analysis of the peak-to-peak value and average value, it was found that the average pressure after separation increases by 90%, but the peak-to-peak value increases by about five times, indicating that the pressure fluctuation after separation is much larger than before separation. The separation flow field under cold flow conditions was simulated using the CFD commercial calculation software Fluent to verify the correctness of the numerical calculations. The fluid–structure coupling analysis was carried out on a large expansion ratio (maximum expansion ratio ε = 48) full-scale nozzle, and the structural deformation characteristics of the nozzle under the separation conditions were studied. The research results show that flow separation occurs in the nozzle with a large expansion ratio under ground conditions. Before the separation point, the pressure pulsation on the nozzle wall is small, and the turbulent pulsation effect is weak. After the separation point, the pressure pulsation increases, and the turbulent pulsation effect is enhanced. When the total pressure decreases, the separation area of the nozzle increases, and the separation flow field presents a strong asymmetry. Reducing the total inlet pressure by half resulted in approximately 50 times the lateral load. Under the combined influence of the ground conditions and low total pressure, the large lateral load caused by the asymmetry of the separation flow field will cause the deformation of the nozzle structure to increase by 5.5 times. This research provides an important reference for the design and experiment of nozzles with a large expansion ratio.

Application study of plug nozzles for solid rocket motors

Experimental Research on Electron Density in Solid-Rocket Motor Plume

Performances Analysis of Asymmetric Minimum Length Nozzles

Experimental and Numerical Studies on Tile-Shaped Aerospike Nozzle

Numerical and Experimental Study of a Plug Nozzle with two Rectangular Inner cells

Design and Verification of Minimum Length Nozzles with Specific/Variable Heat Ratio Based on Method of Characteristics

STUDY ON NUMERICAL SIMULATIONS OF A PLUG NOZZLE FOR ROCKET ENGINE

Numerical Investigation of Separated Plug Nozzle Flow

Design and Optimization of Three-Dimensional Supersonic Asymmetric Truncated Nozzle

Research on flow field characteristics of nozzle plume for a solid rocket motor

Study on the Nozzle of the Rocket Assisted Engine of BB/Rocket HE Shell

Experimental Studies on Plug Nozzle Performance by Changing the Angle of the Primary Nozzle

Study on Separation Characteristics of Nozzles with Large Expansion Ratio of Solid Rocket Motors

Preliminary experimental study on combustion characteristics in a solid rocket motor nozzle based on the TDLAS system

Comparison Of Solid Rocket Motor Thrust Modulation Technique

Numerical study of swirl nozzle internal flow field : Launcher Technology

Numerical Simulation and Design for Aerospike Nozzle

Based on Fluent Numerical Calculation of Refractive Index on Rocket Engine Nozzle Plume

A New Design Method of Single Expansion Ramp Nozzles under Geometric Constraints for Scramjets

Numerical Simulation of Tail Flow Field of Four - Nozzle Solid Rocket Engine

Experimental investigation of internal and external flow fields of jetting nozzles with different structures