Abstract:The aim of this study is to investigate the effect of flash boiling on global structures of n -heptane sprays formed by a multi-hole injector in a wide range of fuel temperatures and ambient pressures at different injection pressures to provide a solid foundation for a new sub-model capable of reproducing spray evolution under flash-boiling conditions using a Lagrangian Discrete Droplet Method (DDM). The experiments were focused on qualitative analysis of the spray structures and quantitative parameters such as axial spray penetration and spray angle. Based on the experimental and literature data, a new sub-model for half of the spray-cone angle (HOCA) was proposed, and the bubble number density was calibrated to simulate the evolution and collapse of flash-boiling sprays accurately. A commercial six-hole injector operating at three injection pressures (5, 10 and 15 MPa) was used to inject n -heptane at three initial temperatures (60, 90 and 120 °C) into a constant volume chamber filled with air at a pressure ranging from 0.01 to 0.1 MPa (absolute). It was observed that regardless of the injection pressure, the effect of flash boiling on the global parameters of the spray was similar. However, due to a stronger axial momentum, the global spray angle was lower for higher injection pressures. Observed changes in the spray parameters were used to create a new simple spray angle formula and calibrate the bubble number density submodel, which was implemented into the AVL FIRETM solver. The model predicted the widening of the near-nozzle spray angle and accurately reproduced the spray collapse. However, it failed to capture an enhanced propagation of the centre part of the collapsed spray front, which was associated with the lack of vapour condensation, which wasn't included in the model.

GDI Spray Calibration under Different Injection Conditions

Experimental Analysis in Dynamics Characteristics of Impinging Spray by a PFI Injector : from Spray Atomization to Fuel Adhesion Formation

Simulation Study on Spray Characteristics of Diesel Engine

Validation of a comprehensive computational fluid dynamics methodology to predict the direct injection process of gasoline sprays using Spray G experimental data

Experimental and Numerical Study of High-Pressure-Swirl Injector Sprays in a Direct Injection Gasoline Engine

Effect of Injection Dynamic Behavior on Fuel Spray Penetration of Common-Rail Injector

Modification and Simulation of Spray Model for GDI Engine

Experimental study and empirical modelling of direct-injection n- heptane sprays formed under flash-boiling conditions

Spray Dynamics of High Pressure Fuel Injectors for DI Gasoline Engines

Spray Model of High Pressure Swirl Injector in the Gasoline Direct Injection Engines

Experimental and Simulation Analysis on Spray and Combustion Characteristics for Different Qualities of Diesel

Effects of Droplet Evaporation on Calibration of KH-RT Break-Up Model for High-Pressure Evaporating Diesel Sprays

On the Fuel Injection Rate Profile As Boundary Conditions for Diesel Spray Combustion Simulations

Characterization of Direct-Injection Gasoline Sprays under Different Ambient and Fuel Injection Conditions

Three-Dimensional Numerical Simulation of Spray, Mixed Gas Formation and Combustion Process for Gasoline Direct Injection Engine

Fundamental spray characteristics of air-assisted injection system using aviation kerosene

Numerical Simulation of Conical Spray on Diesel Engine with Various Injection Strategies

Numerical study of pressure swirl spray using an improved KIVALES with dense grid for GDI engine

Numerical Analysis of Deposit Effect on Nozzle Flow and Spray Characteristics of GDI Injectors

An Experimental and Numerical Investigation on Characteristics of Methanol and Ethanol Sprays from a Multi-hole DISI Injector

Numerical Study of the Impact on High-Pressure and Evaporating Spray Behavior of Nozzle Cavitation at Typical Diesel Engine Conditions