Effect of air and gas dilution on combustion and emission characteristics in alcohol-gasoline fueled SACI engine
Xiaona Li,Fangxi Xie,Linghai Han,Yanfeng Gong,Xiaoping Li,Beiping Jiang,Yu Liu
DOI: https://doi.org/10.1016/j.enconman.2024.118631
IF: 10.4
2024-06-09
Energy Conversion and Management
Abstract:Promoting the use of renewable, clean-burning fuels like methanol and ethanol is a crucial strategy for the engine sector to meet carbon peak and carbon neutrality targets. Spark-assisted compression ignition (SACI) can achieve high thermal efficiency with low levels of pollution. The dilution components and dilution amount are critical elements that impact SACI combustion performance. As a result, in order to encourage the advancement of energy-saving and carbon-reduction work in engines, this research studies the SACI of methanol gasoline and ethanol gasoline at various air dilution and exhaust gas dilution ratios. This article alters the volume of exhaust gas in the cylinder by modifying the variable valve timing and lift. The results showed that raising the dilution rate increased the spark delay and combustion duration, while also delaying auto-ignition. A dimensionless evaluation was proposed, indicating that exhaust gas dilution causes a greater delay in the combustion process than air dilution. When the dilution increases, the maximum torque ignition timing (MBT) must be advanced to maintain good combustion performance. The addition of methanol and ethanol can also impact SACI's combustion process. The effect of exhaust dilution on spark delay for gasoline, E15(15 % volume ethanol + 85 % volume gasoline), M15(15 % volume methanol + 85 %volume gasoline), and M30(30 % volume methanol + 70 % volume gasoline) steadily increases, although the effect of air dilution is minimal. At each dilution rate, E15 and M15 auto-ignition earlier than 92 gasoline, with M30 igniting first. In addition, the combustion noise of E15, M15, and M30 is louder than gasoline. M30 has the highest combustion efficiency, almost 5 % greater than gasoline, and the maximum improvement rates of fuel consumption for gasoline, E15, M15, and M30 are 16.28 %, 17.48 %, 19.05 %, and 22.02 %, respectively. The auto-ignition corresponding to optimal fuel consumption under various dilution rates ranges from 8.75 to 12.2° CA. The optimal auto-ignition of air dilution combined with M30 occurs earliest, around 8.75°CA. Exhaust gas dilution significantly lowered nitrogen oxide (NOx) emissions from four fuels. In the M30, exhaust gas dilution can reduce NOx emissions by up to 83 %. The air dilution approach can achieve the best balance of fuel consumption and NOx emissions, lowering both. Air dilution is more effective at reducing hydrocarbon (HC) emissions. The inclusion of methanol and ethanol helps to reduce HC emissions. M30 decreases HC emissions by 43.4 % when compared to gasoline with a 22 % air dilution.
energy & fuels,thermodynamics,mechanics