Abstract:Thermal fatigue is a potentially significant degradation mechanism in Nuclear Power Plants (NPP). For the fatigue analysis, the thermal load information about components must be determined firstly. In this paper, an experimental study was carried out to obtain local fluid temperatures and local heat transfer coefficients for the safety injection nozzle component in reactor coolant system (RCS). In this mixing tee component a hot jet issues into a cold cross-flow stream from an oblique pipe and the turbulent mixing of two fluids induces local cycling stresses on the adjacent piping wall. Experiments were performed using a special-made heat fluxmeter, which can measure the mixed fluid temperature close to the wall and the heat transfer coefficient between the fluid and the wall. Plexiglass and metallic 1/9-scale mockups were manufactured for flow visualization and heat transfer tests, respectively. All tests were conducted at range of 0–40 for the jet-to-cross-flow velocity ratio. The flow visualization test has obtained general pattern of the flow and identified sensitive zones in the component where the jet and cross-flow interact intensively to cause thermal fatigue more possibly. In the heat transfer test, heat fluxmeters were positioned in the wall at these sensitive zones. The measurement results of temperatures and heat transfer coefficients have been discussed in detail in the paper. These experimental results allow us improving the state of knowledge of the thermal load to be used in the industrial mixing tees in operating for long lifetime assessment and for the design in the basic Nuclear Power Plants.

Numerical Analysis of Fluid Mixing Characteristics in Cold Leg and Downcomer under High Pressure Safety Injection

CFD simulation on the transient process of coolant mixing phenomenon in reactor pressure vessel

ICONE23-1996 CFD SIMULATIONS OF THERMAL MIXING AT ECC SAFETY INJECTION FOR SINGLE PHASE AND AIR-WATER BUBBLY PHASE FLOW

Numerical Research on Thermal Mixing Characteristics in a 45-Degree T-junction for Two-Phase Stratified Flow During the Emergency Core Cooling Safety Injection

Analysis of the Flow Distribution and Mixing Characteristics in the Reactor Pressure Vessel

Study on the Coolant Mixing Phenomenon in a 45° T Junction Based on the Thermal-Mechanical Coupling Method

Numerical Simulation on Near Wall Fluid Temperature of Non-Isothermal Jet with Cross-Flow for Safety Injection Inclined Tube in Reactors

Numerical Analysis on Subcooled Boiling in PWR Coolant Channel Based on a Modified Multi-Scale Interface Model

Simulations of ecc safety injection for single phase and stratified phase flow

Multiscale Thermal Hydraulic Study under the Inadvertent Safety Injection System Operation Scenario of Typical Pressurized Water Reactor

Experimental Investigation on Heat Transfer Characteristics in a Safety Injection Nozzle Component in PWR

CFD Analysis on Subcooled Boiling Phenomena in PWR Coolant Channel

Numerical Investigation on Boiling Crisis in a Full-Length 5 × 5 Fuel Assembly under Typical Pressurized Water Reactor Conditions

The Thermal-Fluid-solid Coupling Effect in Nuclear Reactor Vessel with Direct Vessel Injection

Experimental and Numerical Investigations on Heat Transfer of Reactor Internals under Direct Injection

Experimental and Numerical Analysis of the Liquid Metal Mixing Phenomenon in Complex Jets of Gen-IV Nuclear System

Numerical investigation on mixing performance in rod bundle with spacer grid based on anisotropic turbulent mixing model

Experiment Research on Thermal Mixing in Horizontal T-Junction: In-Pipe Temperature and Flow Characteristic Research

Numerical Investigations of Thermal Mixing Performance of a Hot Gas Mixing Structure in High-Temperature Gas-Cooled Reactor

Study on Structural Response of Reactor Vessel under Direct Safety Injection

Analysis Of Fuel Coolant Interaction In Pwr With Experiment And Computer Code