Abstract:In order to ensure safety and reliability, some safety-related electrical and electronic (E/E) systems in vehicles need to be designed as a whole-redundancy system. Although ISO 26262 provides guidance for the analysis of random hardware failure, the problem of estimating whether the safety-related E/E systems, especially whole-redundancy system can meet the index of the ASIL level in ISO 26262 is still unsolved. Fault tree analysis (FTA) is one of the basic methods to analyze random hardware failure of a vehicle's E/E systems quantitatively. In generic FTA, the quantitative analysis of dynamic logic gates, which usually exist in the fault tree of whole-redundancy system, cannot be calculated. Meanwhile, Markov chain can solve the problem of quantitative calculation of dynamic fault tree, but brings a side-effect of complicating the calculation of static logic gates in fault trees. In order to evaluate random hardware failure of a vehicle E/E system more concisely and effectively, and to estimate if a new safety-related E/E system's random hardware failure rate can meet the index demand in ISO 26262, this study proposed a mixed model based on FTA and Markov chain. First, the definition of random hardware failure and fault classification were clarified. Then, a mixed model based on FTA and Markov chain was proposed. Finally, a whole-dual-redundancy steer by wire system was used as an example to test the validity of the mixed model. This study not only proposed a new mixed model based on FTA and Markov chain for the calculation of a whole-redundancy system's random hardware failure rate, but also provided a new quantitative validation method for safety-related E/E systems in vehicles that need to meet the reliability index requirement in ISO 26262.

Numerical Simulation of Reliability of Nuclear Power Plant Repairable System with Multi-failure Behavior

Numerical Simulation to Reliability Analysis of Fault-Tolerant Repairable System

Digital Simulation of Reliability Qualitative Analysis of Fault Tree in Nuclear Power System

Dynamic Reliability Assessment of Protection System Based on Dynamic Fault Tree and Monte Carlo Simulation

Reliability Analysis of Nuclear Power Plant Electrical System Considering Common Cause Failure Based on GO-FLOW

SFRs-based numerical simulation for the reliability of highly-coupled DFTS

Review of Dynamic Reliability Methodology in Probabilistic Safety Assessments of Nuclear Power Plants

Reliability Analysis for Continuous Operation System in Nuclear Power Plant

System Reliability Simulation Based On Minimal Cut Sets

Risk Assessment for Cascading Failures of Complex Power System

An Approach for the Dynamic Reliability Assessment of the Digital Power Control System for Nuclear Reactor

Reliability And Inspection Policies Study Of Repairable System With N Kinds Of Repairmen

Dynamic Fault Tree Generation and Quantitative Analysis of System Reliability for Embedded Systems Based on SysML Models

A Multi-state Degradation Model for Reliability Assessment of Multi-component Nuclear Safety Systems Considering Degradation Dependency and Random Shocks

ICONE23-1293 APPLICATION OF SUBSET SIMULATION METHODS TO DYNAMIC FAULT TREE ANALYSIS

Reliability Analysis of Active Reactor Pit Flooding Function of EHR DFT System of a NPP Using an Enhanced Component-Connection Method

Research on the Model and Software Package for Ship Reliability Analysis

Software reliability growth model of reactor protection system based on ratio analysis of critical faults

Reliability analysis of non‐repairable systems modeled by dynamic fault trees with priority AND gates

A mixed model to evaluate random hardware failures of whole-redundancy system in ISO 26262 based on fault tree analysis and Markov chain

Numerical simulation of typical abnormal operating conditions in the secondary circuit system of a Hua-long Pressurized Reactor nuclear power unit