Abstract:NHR-200-II is a small integrated pressurized water reactor with 200 MW core thermal power. The core heat is transferred to two independent intermediate circuits via fourteen in-vessel primary heat exchangers (PHE), and the heat in the intermediate circuits is transferred to feedwater by two steam generators (SG) in the two intermediate circuits respectively. A passive residual heat removal (PRHR) branch is connected to each intermediate circuit to remove core decay heat under postulated accidents. During normal operation, PRHR branches are isolated by valves while SG branches in intermediate circuits are open. The valves in PRHR branches will be opened and the isolation valves of SG branches will be closed during decay heat removal scenarios. The decay heat removal capacity of NHR-200-II PRHRS could be seriously deteriorated once the isolation valves for SG branches fail to close, which was confirmed in a scaled integral test loop previously. Current understanding of PRHRS’s thermal-hydraulic characteristics with possible isolation failure in SG branches is limited. In this paper, the NHR-200-II PRHRS is modeled with RELAP5 considering the case of success and fail to isolate SG branches. A series of numerical simulations are carried out to study the impact of various parameters, such as the initial temperature, the size of the intermediate circuits’ header, and the initial flow direction in the intermediate circuits. Oscillatory flow is found when SG branches fail to be isolated under certain parameters combinations. An improved PRHRS design is purposed to eliminate possible flow oscillations, and the purposed improved design are tested by numerical simulations.

Numerical simulation of typical abnormal operating conditions in the secondary circuit system of a Hua-long Pressurized Reactor nuclear power unit

Model Simplification of Nuclear Power Plant for Power System Dynamic Simulation

A Simplified Practical Model of AP1000 Nuclear Power Plants for Power System Dynamic Simulations

A Simulation Method for Nuclear Power Plant with High-Temperature Gas-Cooled Reactor

Dynamic Characteristics Analysis of NuScale in Frequency Domain

Real-time simulations to enhance distributed on-line monitoring and fault detection in Pressurized Water Reactors

Modeling and Simulation of BWR Mechanism Based on RELAP5

A lumped-parameter dynamical model of a nuclear heating reactor cogeneration plant

Operation and Control Simulation of a Modular High Temperature Gas Cooled Reactor Nuclear Power Plant

Dynamic Modeling of the NSSS Based on NHR200-II Nuclear Heating Reactor

Nonlinear dynamic model of 200 MW nuclear heating reactor

Dynamic simulation and optimization of load change operation of high-temperature gas-cooled reactor pebble-bed module

Simulation Study on the Condensing System of High-Temperature Reactor Demonstration Power Station HTR-PM 200 Based on Vpower

Transient Characteristics of Typical Design Basis Accidents in Integrated Small Reactor NHR200-II Using RELAP5 Model

A Nodal Dynamic Model For Control System Simulation Of The Htr-Pm Reactor Core

Dynamical Modeling and Simulation of the Six-Modular High Temperature Gas-Cooled Reactor Plant HTR-PM600

Simulation for the secondary loop of the Chinese 200Mwe HTR-PM base on vpower

Dynamic Mathematical Model of Low-Temperature Reactor of Nuclear Power Plant

Analysis of Transient Characteristics and Design Improvement of the Passive Residual Heat Removal System of NHR-200-II

Dynamic models of Tianwan nuclear units and their response to system disturbances of Jiangsu Power Grid

Dynamic model for control system design and simulation of a low temperature nuclear reactor