Abstract:The effectiveness of in-vessel retention (IVR) of core melt during severe accident in light water reactor strongly depends on whether the heat removed from boundaries could exceed the heat generated in the molten pool in lower head of reactor pressure vessel (RPV). Natural convection in the oxidic pool plays a key role in determining the heat transfer behavior inside the molten pool. A Molten pool Oxide-layer heat tRaNsfer experiment (MORN) facility was built to investigate the heat transfer characteristic of the molten oxidic pool with the intention to verify the heat transfer correlation of the pool. The test facility consists of a three dimensional hemisphere test section with an inner radius of 0.4 m. The outer boundary of the test section could be cooled by different methods (radiation or convection), so as to study the influence of external cooling condition on the crust formation of oxidic pool. Three kinds of material have been chosen as the simulants. They are water, NaNO3/ENO3(mole ratio 1:4) and a non-eutectic binary mixture of calcium-boron oxide (30 wt%CaO-70 wt% B2O3) respectively. At first period, several water and salt experiments with the melt height of 340 mm were performed and the data were analyzed. Though the normalized temperature distribution of the pool was nearly the same between water and salt experiments, the heat flux across the side wall differed much. The heat flux distribution of the water experiment rose nearly linearly with polar angle till to the melt surface. The heat flux of salt experiment at the low angle was larger than that of water, decreased slightly with angle increasing and then rose quickly till to the melt surface. This is consistent with the LIVE and COPRA experiments with the same boundary condition. The maximum normalized heat flux of the water experiment was approximate 1.6 and that of the salt experiment was about 2.2. The downward heat transfer of MORN is smaller than the correlation derived by COPO, mini-ACOPO and BALI experiments, but is consistent as LIVE, COPRA experiment.

Experimental Study on Heat Transfer Characteristics in Corium Pool with High Rayleigh Number

Three-dimensional Experiment of Heat Transfer for Molten Oxidic Pool

Turbulent Convection Experiment at High Rayleigh Number to Support Cap1400 Ivr Strategy

Investigation on Three-Layer Coupled Molten Pool Heat Transfer Experiment with Three Different Materials

Numerical investigation of cooling ability in heat-generating porous debris bed after severe accident in PWR

Heat transfer behaviors in corium pools under swinging conditions

SAMPO-P: A prototypical scale low-temperature experiment on two-layer melt pool heat transfer in LWR lower head

Experimental Investigation on Heat Transfer Characteristics of Oxide Layer of Molten Pool

Experimental study on heat transfer in vertical cooling tube cooled by downward flow in the passive heat removal system of SCWR

Heat Transfer Experiment with the Prototypical Ra Number of Heavy Metallic Layer in IVR Strategy

Dynamics of Heat Transfer in the Melt Pool at Nuclear Severe Accident Conditions

Turbulent convection experiment to support ivr strategy

Preliminary Investigation of THFR Passive Residual Heat Removal System

Experiment investigation of a secondary PRHR cooling effect on an integral facility after a LOCA accident

Design and Evaluation of Mitigation Measures for Tsinghua High Flux Reactor Loss-of-Coolant Accidents

Numerical Investigation of Natural Convective Condensation with Noncondensable Gases in the Reactor Containment after Severe Accidents

CFD study on flow-boiling characteristics and predicting critical heat flux under natural circulation conditions of IVR-ERVC

Experimental Research On Steam Condensation On Cold Surface: Facility Design

Study on the Calculation Method of Molten Pool Decay Heat Distribution under IVR Condition

Experimental Investigation of Pool Entrainment in High Gas Flux Region

Heat transfer characteristics of passive containment cooling system with equal height difference under steady-state conditions