Abstract:With increasing requirements for online monitoring of overhead transmission lines (OTLs) in smart grids, contact-free measurement technologies have been updated these decades. However, the contactless sensors in past research are still limited to the application environment like wind deflection. This article proposes an advanced detection approach with a novel structure to enhance the possibility of implementation and reduce cost. Three pairs of detection probes arranged in a curved pattern can collect differential voltage signals based on the principle of electric field radiation. With three-phase vector decomposition, the nine unknown variables including the voltage to be measured and the status of lines (sag and wind deflection) in nine equations can be constructed. The voltages to be measured can be calculated by solving this nonlinear equation system by iteration. Also, the position of the device installation is optimized by the particle swarm optimization (PSO) algorithm regarding accuracy. The whole measurement device can be easily implemented on the towers according to the distance of insulation requirement regardless of the position of lines. The simulation of level 110 kV is investigated and a model system is built to measure a lower-level voltage for verification. The results show that the proposed non-contact OTL voltage approach can reach the desired accuracy with low costs and monitor the status of lines.

Feasibility Study Using Vibration Measurement to On-line Detect the Contact Condition of OLTC

Fault Diagnosis of OLTC Based on Time-Frequency Image Analysis of Vibration Signal

Study on wavelet transform used for fault diagnosis of on-load tap changers based on vibration signal analysis

Vibration Monitoring of On-load Tap-changer by Resonance-based Sparse Signal Decomposition

On-Line Monitoring and Fault Diagnosis of Oltc Mechanical Performance

Experimental Investigation on Electrical and Mechanical Vibration Responses of Diverter Switches Within OLTCs

Vibration Monitoring of Converter Transformer Onload Tap-Changer Using Phase Space Reconstruction and Poincare Section

Mechanical Condition Monitoring of On-load Tap Changers Based on Chaos Theory and K-means Clustering Method

Mechanical Condition Detection of On-Load Tap-Changer in Converter Transformer Based on Narrowband Noise Assisted Multivariate Empirical Mode Decomposition Algorithm

ON-LINE DETECTION OF OLTC MECHANICAL PERFORMANCE

Early Warning Of Current-Carrying Faults Based On Deterioration Assessment Of Electric Contacts

On-line Monitoring and Characteristic Analysis of Converter Transformer Vibration

Joint Analysis of Vibration Signals and Switching Sequence Features of A Vacuum On Load Tap Changer

On-line Monitoring Method for Mechanical Characteristics of Vacuum Circuit Breakers

Fault Diagnosis of On-Load Tap Changer Based on Optimized Empirical Modal Decomposition Algorithm

Experimental research on the switching characteristics of on-load tap changers

Application Research on Transformer On-Line Monitoring with Vibration Method

Research on Vibration Signal of Transformer On- load Tap Changer Based on Kurtosis and Tunable Q-factor Wavelet Transform

On-line diagnosis for a transformer winding's stateunder short-circuit shock

Non-Contact Voltage Reconstruction Method Based on Dual-Pin Type Probes Structure and Measuring Point Optimization for AC Overhead Transmission Lines

Design and Research of AC Test System for On-Load Tap Changer