Abstract:Both brushed dc motors and brushless dc motors have a wide range of applications, but mechanical commutating devices have the problem of harmful commutation arcs, and electronic commutating devices increase the cost of control systems. The uncontrolled mechanical–electronic hybrid commutating device passively controls the voltage of the freewheeling commutator segment through the capacitor, but the capacitor, inductor and resistor with fixed parameters in the freewheeling circuit are difficult to apply to the entire operating range. Therefore, this article proposes a controlled mechanical–electronic hybrid commutating device and a position sensorless control method. The mechanical component realizes the conduction mode of 120$^{\circ }$ square waves through brushes and a mechanical commutator. The electronic component actively controls the voltages of the commutator segments through the power electronic switches in the commutation circuit so that the brush and the newly separated commutator segment remain equipotent, and the gap between them does not bear voltage, which is equivalent to operating in the brush-slip ring state and completely solves the problem of sparking and arcing during the commutation process. The controlled hybrid commutating device requires only two switches to obtain the same commutation effect as the electronic commutating device with six switches and does not require a position sensor or control chip, which reduces the system cost. The validity and feasibility of the controlled mechanical–electronic hybrid commutation theory and device are verified by experiments.

Angle Commutation Compensation of the Sensorless Brushless DC Motor

A Novel Adaptive Commutation Angle Method for Single Phase BLDC Motor

Sensorless Control Of Permanent Magnet Synchronous Motors With Compensation For Parameter Uncertainty

Speed-sensorless Direct Torque Control System of Induction Motor

Closed-loop correction strategy for commutation deviation of BLDC motor based on internal power factor angle detection

Analyses and Compensation of Rotor Position Detection Error in Sensorless Pm Brushless Dc Motor Drives

Analytic Investigation on Commutation Angle of Brushless DC Motors with 120° Voltage Source Inverter

Fast Self-Correction Commutation Method for High-Speed Sensorless BLDCMs With Nonideal Asymmetric Back EMF

Analysis of Inter-Turn Short-Circuit Faults in Brushless DC Motors Based on Magnetic Leakage Flux and Back Propagation Neural Network

The compensation of speed ripple caused by the angle-measuring error of inductosyn using neural network

A mechanical sensorless control system for salient-pole brushless DC motor with autocalibration of estimated position angles

Auto-correction Commutation Method Based on Phase Voltage Threshold for Position Sensorless Brushless DC Motor

Design of Dual Mode Brushless DC Motor Controller Based on Position Sensor or Sensorless

Reasearch on Sensorless PM Brushless DC Motor Starting Control

Neural Network Control Of Electric Vehicle Based On Position-Sensorless Brushless Dc Motor

Research and Verification of a Novel Sensorless Control Algorithm for Brushless Direct Current Motor

A PLL-Based Novel Commutation Correction Strategy for a High-Speed Brushless DC Motor Sensorless Drive System

Research on Sensorless Vector Control for Air-conditioning Compressor

Sensorless control and start-up strategy of permanent magnet synchronous motor

Sensorless Control of Brushless DC Motor of Air Conditioner in FCV

A Controlled Mechanical–Electronic Hybrid Commutation Theory and Position Sensorless Control