Abstract:Agile development is considered as an emerging trend in hardware design, and NoC-based multi-IP integrated system has become the mainstream solution. The most critical challenge of this solution is to design a common efficient NoC with ultra-high throughput and low-cost routers to meet the communication characteristics of varied applications. Usually, NoC can not achieve both the gains from high throughput and low cost because high-throughput router architectures need complex virtual channel control logic to ensure that the power consumption and area of buffers will not be too large. Meanwhile, the low-cost router architecture is difficult to achieve higher throughput by increasing the number of buffers due to its simple control circuits. Moreover, most routers in NoC are optimized only for specific applications. To address the problem, this paper presents a “viaduct theory” for throughput optimization and realizes a common NoC router architecture for different scenario requirements (CRAFT router). Firstly, we improve the top boundary of the router throughput with the fully-connected crossbar switch, which is an expensive solution for high throughput. Secondly, we use a method similar to the ring-decouple theory in low-cost routers to reduce the number of router buffers while maintaining high throughput. The experimental results show that the throughput for the low-cost program is 15.4% higher than the conventional router with the same overhead. For the high-performance program, our router saves 50% hardware overhead compared with fully-connected routers with the same throughput; The maximum throughput that can be achieved is 26.3% higher than conventional routers, and 14.2% higher than the other state-of-the-art designs.

An Improved Router Packet Forwarding Model

A multi-path routing method with shared buffer on NoC

A Novel Modeling Method for Analysis of IP Networks

GreenRouter: Reducing Power by Innovating Router's Architecture.

High Performance Control-Plane Communication Model for Scalable Routers

A Novel Model to Analyze the Performance of Routing Lookup Algorithms

An Effective Forwarding Model for Tunneling Transmission System Based on Table Optimization

An adaptive buffer regulating scheme for on-chip routers

Power-proportional Router: Architectural Design and Experimental Evaluation

Green Router: Power-Efficient Router Design

Analysis and Modeling of Router Based on M/D/1/B Queuing Model for Networks-on-Chip

A Hybrid Router Combining Circuit Switching and Packet Switching with Virtual Channels for On-Chip Networks

A New Heterogeneous Packet Processing Architecture and Its Analytical Performance Model

Model of Network-On-Chip Routers and Performance Analysis

Research on Switching Throughput of Traffic Manager in Core Routers

Routing Management Model in Distributed Routers

Toward Power-Efficient Backbone Routers

Modeling Ccn Packet Forwarding Engine

Improved network mobility protocol with flow balance and route optimization support

CRAFT: Common Router Architecture for Throughput Optimization.

Study on a Packet Scheduling Algorithm in High Performance Routers