Design and test of high repetition frequency photon counting lidar prototype

Ao-you WANG,Yu-liang TAO,Xu LI,Chun-hui WANG,Huan PENG,Guang WU,Long WANG,Jing-tao ZHANG
DOI: https://doi.org/10.3969/j.issn.1001-5078.2017.07.003
2017-01-01
Abstract:In order to verify the space borne three dimensional lidar imaging technology,a ground scaled model lidar prototype is designed based on high repetition rate photon counting technique,and it has the characteristics of sub-field,non-scanning and multi-channel.The system uses two high repetition frequency,micro-pulse lasers(repetition frequency 10 kHz,single pulse energy 60 μJ),and the multi-channel detection is achieved based on large spot multi-sub-array photon detection.Besides,the time interval and time correlation statistics for single photon response time are measured by using FPGA based time coincidence count signal processing technology.Then the target distance can be obtained according to the target response time consistency and randomness of the noise response.In the field experiment,the distance of the buildings that is more than 10 km was measured,and the ranging accuracy is better than 0.3 m,detection probability is more than 99%,and the influences of different atmospheric visibilities on ranging are compared.The system validates the feasibility of multi-sub field of view of space born lidar and fiber optic focal plane receiving scheme,and proves the ranging accuracy and adaptability of lidar based on photon counting.
What problem does this paper attempt to address?