Abstract:Passive location based on TDOA (time difference of arrival) and FDOA (frequency difference of arrival) is the mainstream method for target localization. This paper proposes a fast time–frequency difference positioning method to address issues such as low accuracy, large computational resource utilization, and limited suitability for real-time signal processing in the conventional CAF (cross-ambiguity function)-based approach, aiming to complete the processing of the target radiation source to obtain the target parameters within a short timeframe. In the mixing product operation step of the CAF, a frequency-domain approach replaces the time-domain convolution operation in PW-ZFFT (pre-weighted Zoom-FFT) to reduce the computational load of the CAF. Additionally, a quadratic surface fitting method is used to enhance the accuracy of TDOA and FDOA. The localization solution is obtained using Newton's method, which can provide more accurate results compared to analytical methods. Next, a signal processing platform is designed with FPGA (field-programmable gate array) and multi-core DSP (digital signal processor), and works by dividing and mapping the algorithm functional modules according to the hardware's characteristics. We analyze the architectural advantages of multi-core DSP and design methods to improve program performance, such as EDMA transfer optimization, inline function optimization, and cache optimization. Finally, this paper constructs simulation tests in typical positioning scenarios and compares them to hardware measurement results, thus confirming the correctness and real-time capability of the program.

Design and Implementation of a Time to Digital Convertor (TDC) Circuit Based on FPGA in Positioning Technology

Low-cost FPGA-based multi-channel TDC with high resolution and density for time-of-flight detectors

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

A 1.15-Ps Bin Size and 3.5-Ps Single-Shot Precision Time-to-Digital Converter with On-Board Offset Correction in an FPGA

A High-Resolution Tdc Implemented In A 90nm Process Fpga

Design of a high-precision time-to-digital converter in an Elitestek Ti60 field-programmable-gate-array

A High-Throughput Vernier Time-to-Digital Converter on FPGAs with Improved Resolution Using a Bi-Time Interpolation Scheme

High-Resolution, Multi-Channel FPGA-Based Time-to-Digital Converter

Two-Stage Clock-Free Time-to-Digital Converter Based on Vernier and Tapped Delay Lines in FPGA Device

A High Resolution Time-to-digital-convertor Based on a Carry-Chain and DSP48E1 Adders in a 28-Nm Field-Programmable-gate-array

A High-Resolution TDC Design Based on Multistep Fine Time Measurement by Utilizing Delay-Adjustable Looped Carry Chains on FPGAs

A high resolution multi-phase clock Time-Digital Convertor implemented on Kintex-7 FPGA

Design and Implementation of High-Precision Timing Module for NR Terminals Based on FPGA

A 5.5 ps Time-interval RMS Precision Time-to-Digital Convertor Implemented in Intel Arria 10 FPGA

Positioning System based on DTMB: Design, Laboratory Test and Field Trial

A high precision TDC based on a multi-phase clock

Design of a High Accuracy and Real-Time Indoor Positioning System Based on Coding Point Identification and Its FPGA Implementation

A Low-Cost FPGA-Based Coarse-Fine Counting Time-to-Digital Converter With External High-Precision Reference Clock

High-Resolution Time-to-Digital Converters Implemented on 40-, 28-, and 20-Nm FPGAs

Design of Multifunction Digital Clock Based on FPGA

High-Precision Joint TDOA and FDOA Location System