Abstract:Silicon technologies for HF applications have been proven for more than two decades, and technologies have greatly evolved. Whether CMOS or BiCMOS technologies, the unique combination of radio frequency, baseband, and digital functions allow a very high level of integration. While it is possible to achieve fully integrated transceivers, the major advantages of these silicon technologies lie mainly in their unparalleled performance in the field of frequency synthesis and frequency conversion. We propose in this paper a review of the major results obtained on these RF components since the beginning of the 2000s, also considering the impact of the technology node. The back-end of line (BEOL) process on which depends the quality of microwave monolithic integrated circuits (MMICs) is briefly presented in the introductory part. If circuit performances are tightly bound to the active devices (i.e., the heterojunction bipolar transistor SiGe HBT or CMOS transistor), passive elements (i.e., quality factor of inductors and varactors, losses of transmission, or interconnection lines) as well as the definition of the substrate also play a major role. The core of the article is oriented toward the noise of synthesized signals and frequency conversion. Frequency synthesis is presented through the analog design of a voltage-controlled oscillator (VCO) or through the direct digital frequency synthesis (DDFS), for which respective figures of merit are presented and discussed in a second section. The spectral purity of the oscillators being decisive in the definition of the throughput of a link is approached through the comparison of different figures of merit (FoM) for a set of circuits achievements over the selected period. If the realization of free oscillators is closely bound to the phase-locked loop (PLL)-type control loop for VCOs, the DDFS solution provides more direct and more flexible alternative at first sight. Therefore, these two solutions are analyzed collectively. Finally, the oscillator integrated in the transmitter or receiver supplies the needed LO (local oscillator) power to the frequency mixer in the frequency conversion module: henceforth, the third part of this study focuses on high-frequency mixer realizations. We thus consider this LO power in some advanced figure of merit mentioned in the second section. The design trade-off of the mixer is presented in an approach combining LO (conversion gain, channel isolation, and phase noise) and RF (HF noise figure and channel isolation) constraints. The final section provides a summary of the results and trends mentioned in the paper.

Model Optimization and Circuit Design of a Frequency Synthesizer

Physical design optimization of MOSFETs for millimeter wave and sub-millimeter wave circuits

Modeling and Simulation to the Design of ΣΔ Fractional-N Frequency Synthesizer

Modeling and Simulation to the Design of EA Fractional-N Frequency Synthesizer

A New Modeling Method of MEMS System's Noise

A novel design optimization method of fully integrated CMOS low noise amplifier

A Low-Phase-Noise UHF-Band Fractional-N Frequency Synthesizer

Behavioral Modeling and Simulation of Fractional-N Frequency Synthesizer

A Modeling Approach For Mixed-Mode Fmcw Synthesizer Allowing Frequency Error Analysis

Comparative Study of Surrogate Modeling Methods for Signal Integrity and Microwave Circuit Applications

Design of Area-Efficient GHz Range Current Mode Frequency Synthesizer Using Standard CMOS Technology

Design Techniques for CMOS Fractional-N Frequency Synthesizer

Design and Implementation of a Frequency Synthesizer with Wide Frequency-Coverage and Low Phase Noise Level

A CMOS Fully Integrated Frequency Synthesizer with Stability Compensation

Frequency planning of radio frequency front-ends receiver

A Novel Architecture for Integrated Cmos Wideband Pll- Based Frequency Synthesizer

Design and Simulation of Spread Spectrum Clock Generator

Building Post-layout Performance Model of Analog/RF Circuits by Fine-tuning Technique

Evolution Trends and Paradigms of Low Noise Frequency Synthesis and Signal Conversion Using Silicon Technologies

An Efficient Mm-Wave Integrated Circuit Synthesis Method With Accurate Scalable Passive Component Modeling

A Novel Fault-Tolerance Design Model for Automatic Synthesis of Circuit Robust to Unknown Fault