Abstract:A coaxial-output capacitor-loaded annular pulse forming line (PFL) is developed in order to reduce the flat top fluctuation amplitude of the forming quasi-square pulse and improve the quality of the pulse waveform produced by a Tesla-pulse forming network (PFN) type pulse generator. A single module composed of three involute dual-plate PFNs is designed, with a characteristic impedance of 2.44 Omega, an electrical length of 15 ns, and a sustaining voltage of 60 kV. The three involute dualplate PFNs connected in parallel have the same impedance and electrical length. Due to the existed small inductance and capacitance per unit length in each involute dual-plate PFN, the upper cut-off frequency of the PFN is increased. As a result, the entire annular PFL has better high-frequency response capability. Meanwhile, the three dual-plate PFNs discharge in parallel, which is much closer to the coaxial output. The series connecting inductance between adjacent two modules is significantly reduced when the annular PFL modules are connected in series. The pulse waveform distortion is reduced when the pulse transfers along the modules. Finally, the shielding electrode structure is applied on both sides of the module. The electromagnetic field is restricted in the module when a single module discharges, and the electromagnetic coupling between the multi-stage annular PFLs is eliminated. Based on the principle of impedance matching between the multi-stage annular PFL and the coaxial PFL, the structural optimization design of a mixed PFL in a Tesla type pulse generator is completed with the transient field-circuit co-simulation method. The multi-stage annular PFL consists of 18 stage annular PFL modules in series, with the characteristic impedance of 44 Omega, the electrical length of 15 ns, and the sustaining voltage of 1MV. The mixed PFL can generate quasi-square electrical pulses with a pulse width of 43 ns, and the fluctuation ratio of the pulse flat top is less than 8% when the pulse rise time is about 5 ns. Published by AIP Publishing.

Optimization of PFN-Marx generator

A Compact High-Power Ultra-Wideband Bipolar Pulse Generator

Investigation on a Novel Multiple-Switch Pulsed Power Technology

Study on a rotational symmetry structure pulse forming network with low-impedance for compact pulse drivers

Performance Improvement For Sub-Nanosecond Marx Generator Based On Avalanche Transistors By Considering The Traveling Wave Process

Theoretical Investigation on Double-Matched Marx Generators

A compact 4 GW pulse generator based on pulse forming network-Marx for high-power microwave application.

Improved Marx Pulse Generator With Auxiliary Trigger Topology (2022)

Comparison of Two Field-Distortion Gas Switches for the Compact Marx Generator

A Long-Pulse Generator Based on Tesla Transformer and Pulse-Forming Network

500Kv Compact Repetitive Marx Generator

High-voltage pulse waveform modulator based on solid-state Marx generator

Design and Simulation of a Compact Sub-Nanosecond Pulse Generator Based on Marx's Circuit Theory of Field-Effect Transistors

Traveling-Wave Marx Circuit for Generating Repetitive Sub-Nanosecond Pulses

Solid-state Marx generator based on saturable pulse transformer and fast recovery diodes

Design of Repetitive Nanosecond Pulse Generator Based on Modularized Marx Circuit and Transmission Line Transformer

Marx Generator Using Power Mosfets

Drivers of small and medium scale electromagnetic pulse simulator based on Marx generator

Parameterized Nanosecond Pulse Realization Through Parametrical Modulation of Timing Sequence of Switches in Marx Circuit

A Coaxial-Output Capacitor-Loaded Annular Pulse Forming Line

Development of a 40kV/20kW, switching-mode pulse forming network charging power supply