Abstract:This paper presents the design of a subsampling wideband 500MS/s 12Bit successive-approximation-register (SAR) analog-to-digital converter (ADC) with sub-2 radix split-capacitor array (SCA). The presented ADC is designed as a sub-ADC for a sample-and-hold-less (SAH-less) 8GS/s time-interleaved (TI) ADC. In addition to the required 16 ADC channels, two additional SAR lanes enable pseudorandom binary sequence (PRBS)-driven channel scrambling. A 1.81 radix is used to achieve 12Bit settling accuracy withing 70ps. Extra scaling capacitors in the SCA enable SAR reference voltage levels near the supply rails, significantly reducing the SCA switch sizes. The necessity of a comparator latch reset phase is eliminated at the cost of higher comparator power consumption by the adoption of a loop-unrolled comparator improving the SAR loop timing. Top-plate charge kickback into the input buffer, a challenge that occurs within TI ADCs, is largely eliminated by implementing an additional reset phase within the SAR algorithm and the use of a boosted input T-switch. SCA and time-interleaved channel mismatch effects are addressed by calibrating each sub-ADC to an extra reference-ADC. The industry grade ADC design, achieves a spurious free dynamic range (SFDR) of 72dB and signal to noise and distortion ratio (SNDR) of 54dB across the entire 4GHz frequency range. Designed in a 28nm CMOS process, each sub-ADC consumes 33mW from 1.8V and 1V. The input buffer frontend uses supply voltages of 2.5V and -1.3V. The overall power consumption of the overall TI ADC is 3W.

Design of a 12 bit 5 kS/s SAR ADC

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

A 15-Bit, 5 MSPS SAR ADC with On-Chip Digital Calibration

Design of an 8-Channel 12bits 1MSPS SAR ADC

An 18-Bit 2MSPS SAR ADC with Double Passive Noise-Shaping Calibration

A 14-Bit 500-Ms/s Pipelined-SAR ADC in 28-Nm CMOS with Foreground and Background Calibration

A Front-End Circuit With 16-Channel 12-Bit 100-Ksps Rc-Hybrid Sar Adc For Industrial Monitoring Application

A 12-Bit 2.32gs/s Pipelined/sar Hybrid ADC with a High-Linearity Input Buffer.

A Digital Background Calibration Scheme for Non-Linearity of SAR ADC Using Back-Propagation Algorithm

Design of a 12-Bit SAR ADC with Calibration Technology

An 18-Bit SAR ADC with Mixed DAC and Capacitive Recombination Calibration

A 12-Bit Self-Calibrating SAR ADC Achieving a Nyquist 90.4-Db SFDR

A Foreground Digital Calibration by Switching Control Scheme for A 12-Bit SAR ADC

A 62.5 Khz-Bw 92 Db-Sndr Noise-shaping SAR ADC with NS-CAL Method

A 16-Bit 300-Ks/s Foreground Calibration SAR ADC with Single-Ended/differential Configurable Input Modes

A 12-Bit SAR ADC with Binary Search Calibration Algorithm for a Split Capacitor

A 7-bit 900-MS/s 2-Then-3-bit/cycle SAR ADC With Background Offset Calibration

Design of a 0.005mm 2 8.5enob 14.9 Fj/conv-Step SAR ADC for Biomedical Application

A 12 Bit 500 MS/s Sub-2 Radix SAR ADC for a Time-Interleaved 8 GS/s ADC in 28 nm CMOS

A Single-Ended 10-Bit 200 Ks/s 607 Μw SAR ADC with an Auto-Zeroing Offset Cancellation Technique

A 12b 200KS/s SAR ADC with novel capacitor switching procedure and digital background calibration