Abstract:For the research on real-time accurate testing technology for the explosion point spatial coordinate of munitions, its currently commonly used methods such as acoustic–electric detection or high-speed imaging are limited by the field conditions, response rate, cost, and other factors. In this paper, a method of spatial coordinate testing for the explosion point based on a 2D PSD (position-sensitive detector) intersection is proposed, which has the advantages of a faster response, better real-time performance, and a lower cost. Firstly, a mathematical model of the spatial coordinate testing system was constructed, and an error propagation model for structural parameters was developed. The influence of the position of the optical axes' intersection as well as the azimuth angle and pitch angle on the test accuracy of the system was simulated and analyzed, thus obtaining the distribution and variation trend of the overall error propagation coefficient of the system. Finally, experiments were designed to obtain the test error of the system for validation. The results show that the system test accuracy is high when the azimuth angle is 20°–50°, the overall error propagation coefficient does not exceed 48.80, and the average test error is 56.17 mm. When the pitch angle is −2.5°–2.5°, the system has a higher test accuracy, with the overall error propagation coefficient not exceeding 44.82, and the average test error is 41.87 mm. The test accuracy of the system is higher when the position of the optical axes' intersection is chosen to make sure that explosion points fall in the region of the negative half-axis of the Zw-axis of the world coordinate system, with an overall error propagation coefficient of less than 44.78 and an average test error of 73.38 mm. It is shown that a reasonable selection of system structure parameters can significantly improve the system test accuracy and optimize the system deployment mode under the long-distance field conditions so as to improve the deployment efficiency.

Relative Sensitivity Analysis of Typical Faults of Armament and Thresholds Achievement Based on Virtual Prototyping

Accuracy Analysis for Digital Boresighting of Aircraft Gun

Preliminary design and dynamical analysis of a new deployable air target

Mathematical Modeling and Simulation of Pneumatic Nail Gun

Co-simulation of self-propelled artillery based on virtual prototype technology

A Virtual Reality Approach to the Assessment of Damage Effectiveness of Naval Artillery Ammunition Against Unmanned Surface Vessels

Experimental Modal Analysis and Research of a Type of Machine Gun Based on the Experiment Bench

Modelling and simulation analysis of man-gun systems with prone position and support

Modeling and Modal Analysis for the Flexible Parts of Machine Gun

Research on the Reliability Design Method of Air-Defense Weapon System with Missile and Gun

The Experimental Modal Analysis of the Anti-aircraft Guns

Target Vulnerability Analysis and Damage Assessment of Main Battle Tank

Functional Damage Assessment Method for Preformed Fragment Warheads to Evaluate the Effect on the Phased-Array Antenna

Design And Implementation Of Air-To-Ground Weapon Launcher Detector Of A Certain Airplane

Integrated Evaluation on Mobile Viability of Air Defense System with Missile and Gun

Virtual Replay of Failure and Design Modification of One-side Ejection Launching System

Present Situation and Development Trend of Effectiveness Evaluation Technology in Gun/Missile Integrated Air Defense Weapon System

Key technologies of dynamic simulation and design for large caliber truck-mounted artillery

Error Analysis and Optimization of Structural Parameters of Spatial Coordinate Testing System Based on Position-Sensitive Detector

Design and simulation research on experimental equipment of gun recoil

Exploring the application of digital twin technology in the field of artillery equipment protection