Abstract:Unmanned Aerial Vehicles (UAVs) have slowly but steadily emerged as a research and commercial hotspot because of their widespread applications. Due to their agility, compact size, and ability to integrate multiple sensors, they are mostly sought for applications that require supplementing human effort in risky and monotonous missions. Despite all of these advantages, rotorcrafts, in general, are limited by their endurance and power-intensive flight requirements, which consequently affect the time of flight and operational range. On the other hand, fixed-wing aircrafts have an extended range, as the entire thrust force is along the direction of motion and are inherently more stable but are limited by their takeoff and landing strip requirements. One of the potential solutions to increase the endurance of VTOL rotorcrafts (Vertical Take-Off and Landing Vehicles) was to exploit the thrust vectoring ability of the individual actuators in multi-rotors, which would enable take-off and hovering as a VTOL vehicle and flight as a fixed-wing aircraft. The primary aim of this paper is to lay out the overall design process of a Hybrid VTOL tilt-rotor UAV from the initial conceptual sketch to the final fabricated prototype. The novelty of the design lies in achieving thrust vectoring capabilities in a fixed-wing platform with minimum actuation and no additional control complexity. This paper presents novel bi-copter that has been designed to perform as a hybrid configuration in both VTOL and fixed wing conditions with minimum actuators in comparison to existing designs. The unified dynamic modelling along with the approximation of multiple aerodynamic coefficients by numerical simulations is also presented. The overall conceptual design, dynamic modeling, computational simulation, and experimental analysis of the novel hybrid fixed-wing bi-copter with thrust vectoring capabilities aiming to substantially increase the flight range and endurance compared to the conventional aircraft rotorcraft configurations are presented.

Design and Modeling of a New Type Vector Thrusting Autorotation Rotor UAV

A Minimal Thrust Vectoring Rotor with Six Degree of Freedom: Design and Analysis

Large-Sized Multirotor Design: Accurate Modeling with Aerodynamics and Optimization for Rotor Tilt Angle

System Design of a Novel Tilt-Roll Rotor Quadrotor UAV

Automated Design Optimization of a Mono Tiltrotor in Hovering and Cruising States

Rotor Cross-Tilt Optimization of Manned Multi-rotor Evtol Aircraft for Yaw Control Efficiency

Design, Analysis, and Testing of a Hybrid VTOL Tilt-Rotor UAV for Increased Endurance

Longitudinal dynamic modelling and control for a quad-tilt rotor UAV

A New VTOL Aircraft

Modelling, design and control of middle-size tilt-rotor quadrotor

Design, Modeling, and Control of a Coaxial Drone

Design and Control of a VTOL Aerial Vehicle Tilting its Rotors Only with Rotor Thrusts and a Passive Joint

Tri-Tilting Rotor Fixed-Wing VTOL UAV: Dynamic Modelling and Transition Flight Control

Design, Modelling and Hovering Control of a Tail-Sitter with Single Thrust-Vectored Propeller.

Lifting-wing Quadcopter Modeling and Unified Control

Modeling and Hover Attitude Control of Tail-Sitter Aircraft

Thrust Vectoring Control of a Novel Tilt-Rotor UAV Based on Backstepping Sliding Model Method

Modeling and the Control Strategy of the Coaxial Contra-Rotating Propeller System

An innovative fuzzy backstepping sliding mode controller for a Tri-Rotor Unmanned Aerial Vehicle

Modeling and Control of an Omnidirectional Hexrotor UAV with Tilted-Rotors

Multiple Modeling and Fuzzy Switching Control of Fixed-Wing VTOL Tilt-Rotor UAV