Abstract:Scramjet inlets typically ingest air that has been processed by a vehicle forebody. The forebody generates entropy and boundary layers that affect the thermodynamic properties of the ingested air and hence influence inlet mass capture, combustion performance and unstart characteristics. This paper investigates the effects of leading edge bluntness on combustion performance of a scramjet at Mach 8 flight conditions, focussing on combustion-induced pressure rise and transition between scram- and dual-mode combustion. Simulations have been performed on a 3D supersonic combustion flow path with length of order 1 m, examining the effects of forebody leading edge radii, finding that a large radius of 0.3% the engine length can produce engine unstart and significantly decrease inlet mass capture by over 45%. An experimental scramjet model has been tested to examine these effects with more reasonable, sharper radii of either 0.02% (sharp case) and 0.05% (blunt case) of the engine length for leading edges of both the forebody and the inlet walls. These experiments show that changing the forebody leading edge radii can have a strong impact on combustion mode within a scramjet flow path, with the blunt leading edge inducing dual-mode combustor earlier than the sharp leading edge. For higher equivalence ratios where both cases produce dual-mode combustion, the sharp forebody leading edge produced an increase of 5% of normalised gross thrust compared to the blunt case, indicating the increased losses for a blunt leading edge. This was consistent with numerical simulations of the two cases at an equivalence ratio of 1.4. These results suggest that changes to leading edge bluntness can influence gross thrust, engine operation mode and even trip the engine into full unstart. Thus, the leading edge radius on a hypersonic vehicle must be controlled over a vehicle's trajectory, and should not be allowed to melt or deform into a larger radius.

Analysis on Performance Influence Factors for Scramjet

Conceptual Design and Optimization of Scramjet Engines Using the Exergy Method

SHOCK INDUCED SEPARATING FLOWS IN SCRAMJET INTAKES

Effects of Scramjet Combustor Configuration on Combustor Performance

On compression level of hypersonic airflow in high-mach scramjet

Thermodynamic analysis on the performance of hydrocarbon fueled scramjet with inlet active cooling

Design optimization and off-design performance analysis of axisymmetric scramjet intakes for ascent flight

Numerical Investigation on Cavity Structure of Solid-Fuel Scramjet Combustor

Aerodynamic Modeling for Hypersonic Flight Vehicles with Account of Scramjet Effects.

The Effect of Leading Edge Bluntness on Scramjet Performance

Effects of the Configuration and Fuel Injection on Scramjet Combustor Performance

Modeling of the non-uniform combustion in a scramjet engine

Aviation kerosene supersonic combustion in dual-mode scramjet

Research on the Zooming Method for Determining the Flow, Heat Transfer, and Infrared Radiation of an Air-Breathing Hypersonic Vehicle Powered by a Scramjet

Experimental Study of the Configuration Optimization of Scramjet Combustor

Scramjet performance for ideal combustion processes

Measurements of Mixing Layers and Vortex Structures of the Strut-Induced Flow in a Scramjet Combustor with PIV and POD

Design space investigations of scramjet engines using reduced-order modelling

Optimization of scramjet inlet based on temperature and Mach number of supersonic combustion

Assessment of influencing factors on the flight performance of J-series fighter jets based on the entropy weight-TOPSIS model

Optimization of Thrust of a Generic X-51 Hypersonic Vehicle