Abstract:Polydimethylsiloxane (PDMS) is extensively used in clinical flexible electronics, due to its biocompatibility and stability. When it is employed in a stretchable epidermal sensor for long-term monitoring, PDMS must have open pores within it to assure the sweat penetration. In the present paper, we focus on the mechanical properties of porous PDMS with different volume porosities at different temperatures. The emulsion polymerization technique is applied to fabricate porous PDMS. By controlling the ratio of water to PDMS prepolymer, different porosities of PDMS were obtained, and elastic moduli of such porous PDMS were measured in experiment. Results indicate that the elastic modulus increases nonlinearly as its temperature rises from 0 °C to 40 °C (a temperature range frequently encountered in clinical applications). Meanwhile, an asymptotic homogenization method (AHM) is employed to theoretically predict the elastic modulus and Poisson's ratio of porous PDMS, whose reliability is testified by comparing the results with experimentally measured data. Further theoretical discussions on mechanical properties are carried out, and results show that the pore size of porous PDMS has almost no effect on the elastic modulus and Poisson's ratio for certain porosities. Porosity of porous PDMS, however, has significant effect on both of these two mechanical parameters. Two fitted nonlinear formulas are then proposed to estimate the elastic modulus and Poisson's ratio of porous PDMS for any volume porosity less than 50%. All the results in the present paper are essential for mechanical design and optimization of clinical flexible electronics based on porous PDMS.

Micro-extrusion Molding of Ultrasonic-assisted Polypropylene Five-lumen Catheter

Three-dimensional numerical simulations and experimental studies on the viscoelastic rheological and deformation behavior of polymer catheter in gas-assisted extrusion processing

Effect of Mold Flow Channel Parameters on Gas-Assisted Extrusion of Medical Microtubules

Micro Pin Extrusion of Metallic Materials Assisted by Ultrasonic Vibration

Preparation of high melt strength polypropylene by the reactive extrusion process and its foaming application

Study on the Extrusion Molding Process of Polylactic Acid Micro Tubes for Biodegradable Vascular Stents

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament

Influence of Gas Inlet Slit Width on Gas-Assisted Plastic Micro-Tube Extrusion

Numerical Simulation and Analysis of the Effect of Some Materials and Processing Parameters on the Gas Assisted Extrusion of Ultra-high Molecular Weight Polyethylene

Experimental And Numerical Analyses On The Poly(Lactide-Co-Glycolide) Hollow Fiber Membranes

Study on the Melt Rheological Characterization of Micro-Tube Gas-Assisted Extrusion Based on the Cross-Scale Viscoelastic Model

Effect of Pressure Difference between Inner and Outer Gas Layer on Micro-Tube Deformation during Gas-Assisted Extrusion

Experimental and Theoretical Study on Mechanical Properties of Porous PDMS

Influence of injection air pressure on the microcapillary formation within extruded plastic films

Porous Morphology and Mechanical Properties of Poly(lactide-Co-glycolide) Hollow Fiber Membranes Governed by Ternary-Phase Inversion

Physical and chemical effects of ultrasound vibration on polymer melt in extrusion

Development of a Subpath Extrusion Tip and Die for Peripheral Inserted Central Catheter Shaft with Multi Lumen

Surface and volume effects in multimodal ultrasonic vibration assisted micro-extrusion forming: Experiments and modelling

Numerical modelling of the viscoelastic polymer melt flow in material extrusion additive manufacturing

Effect of rapid heating cycle injection mold temperature on crystal structures, morphology of polypropylene and surface quality of plastic parts

Numerical and Experimental Studies on the Improvement of Gas Chamber Structure During Gas-Assisted Extrusion