Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Development of correlation for mass flow rate through varying diameter capillary tube

Numerical Simulation and Experimental Study of Capillary Tubes

A generalized correlation for the characteristics of adiabatic capillary tubes

An Assessment of Friction Factor and Viscosity Correlations for Model Prediction of Refrigerant Flow in Capillary Tubes

Study of Heat Transfer for Co2 Flow Boiling in Horizontal Small Diameter Tubes

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Development of a New Correlation for Saturated Flow Boiling Heat Transfer in a Helically Coiled Tube

Development of a stepped capillary tube as a low cost throttling device for a residential heat pump system

Development of a correlation for pressure drop of two-phase flow inside horizontal small diameter smooth and microfin tubes

Two-phase Heat Transfer Correlations in Three-Dimensional Hierarchical Tube

Heat Transfer Correlations for Single-Phase Flow, Condensation, and Boiling in Microfin Tubes

Evaluation of Prediction Methods for Heat Transfer Coefficient of Annular Flow and a Novel Correlation

Correlations of Two-phase Friction of Refrigerant in Horizontal Smooth Tube with 2.5 mm inside Diameter

A General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes

Dimensional Analysis and Neural Network Correlation of Choked Flow Rate through Adiabatic Capillary Tube

A New Correlation For Subcooled Flow Boiling Heat Transfer In A Vertical Narrow Microchannel

An Investigation On Existing Correlations For Prediction Of Hfc-134a In-Tube Boiling Heat Transfer Coefficients Based On Experiment

Evaluation of prediction models on frictional pressure drop for condensation flow in horizontal circular tubes

A New Modeling Method to Evaluate Effective Forced-Convective Heat Transfer Rate of Pipe Flow with Endothermic Chemical Reactions

A General Correlation for Condensation Heat Transfer in Micro-Fin for Herringbone and Dimple-Texture Tubes