Abstract:Cement industry is estimated to account for ~6–7% of anthropogenic CO 2 emissions globally. Therefore, the identification of innovative solutions for their mitigation is both a priority and a challenge. The integration of carbon capture and storage technologies into the industrial production process is considered among the most viable solutions for this purpose, and calcium looping (CaL) represents one of the most promising. A key research challenge points to maximize process efficiencies and minimize production cost to decouple cement production from carbon emissions. The carbon capture process proposed in this work is a looping system where CO 2 is absorbed by calcium oxide (CaO) in the first reactor (carbonator) and the calcium carbonate (CaCO 3 ) produced is regenerated in an oxy-fired calciner. During calcination, CO 2 is released from the sorbents, purified, compressed, and then made available for geological storage. In this study, greenhouse gas (GHG) emissions related to two cement production systems with CaL carbon capture are evaluated: the tail-end CaL carbon capture and the integrated CaL carbon capture. The carbon footprint is complemented with the assessment of the resources depletion mineral and elements and the demand of primary energy. An eco-design approach was pursued by carrying out a life cycle assessment to identify the environmental hotspots and which CaL integration approach presents a higher potential for cement industry decarbonization. The results of the analysis were compared with a conventional cement production process. The results show that the GHG emissions may be reduced by 74% with a tail-end approach and 71% when the CaL is fully integrated into the cement production process. When a future perspective, with higher penetration of renewable energy resources into the electricity sector, was modeled, the results showed that CaL integrated into the clinker production process is more promising in terms of reduction of the carbon footprint, rather than the tail-end solutions. Primary energy consumption from non-renewables is substantially impacted by CaL, with the integrated CaL configuration showing to be a more efficient solution because of less primary energy consumption (coal).

Life-cycle greenhouse gas emissions and cost of potassium extraction and CO2 mineralizationvia K-feldspar—industrial solid waste calcination

Analyzing the upscaling potential and geospatial siting of calcination-free calcium hydroxide production in the United States

A novel process for one-step preparing potassium-containing fertilizer using red mud or CFA synergistic extraction of alumina

Emerging CO2-Mineralization Technologies for Co-Utilization of Industrial Solid Waste and Carbon Resources in China

Carnallite-Derived Solid Waste as Potassium (K) and Magnesium (Mg) Source in Granulated Compound NPK Fertilizers

Extraction of potassium from K-feldspar via the CaCl2 calcination route

A sustainable temperature-swing process for CO2 capture and mineralization at below 100 °C using a recyclable chelating agent and bottom ash

Evaluation on liquefaction effect of potassium dissolution extraction from low-grade solid potash ore in Qarhan Salt Lake, northern of Tibetan Plateau

Study on synergistic leaching of potassium and phosphorus from potassium feldspar and solid waste phosphogypsum via coupling reactions

A Novel Method for MSWI Fly Ash Resource Based on Calcium Component Regulation and CO2 Mineralization

A novel method for MSWI fly ash resource based on calcium component regulation and CO 2 mineralization

CO2 Mineralization and Utilization by Alkaline Solid Wastes for Potential Carbon Reduction

Evaluating the Carbon Footprint of Cement Plants Integrated With the Calcium Looping CO2 Capture Process

Effect of manganese salts on recovery of potassium from K-feldspar by means of a calcination reaction in the chloride salts-calcium carbonate system

An Efficient Method for Carbon Dioxide Sequestration Using Semidry Flue Gas Desulfurization Ash

Performance and mechanisms of alkaline solid waste in CO 2 mineralization and utilization

Performance and Mechanisms of Alkaline Solid Waste in CO2 Mineralization and Utilization

Stepwise extraction of lithium and potassium and recovery of fluoride from aluminum electrolyte wastes through calcification roasting-two-stage leaching

Life cycle assessment of beneficial use of calcium carbide sludge in cement clinker production: A case study in China

Recycling of calcined carbonated cement pastes as cementitious materials: Proposed CCUS technology for calcium looping

Comprehensive assessment of cement kiln co-processing under MSW sustainable management requirements