Abstract:Steam assisted gravity drainage (SAGD), as a commercially proven high ultimate recovery process for heavy oil and bitumen is energy intensive and may be limited by high usage of water. In the recent years, numerous methods to combine solvent and heat have been proposed for the in-situ recovery of bitumen. Among these methods, N-Solv (heated solvent vapor injection) and EBRT (enhanced bitumen recovery technology) utilize heated solvent vapor to extract heavy crudes under in situ conditions. These methods take the advantage of partial in situ upgrading of oil with much lower consumptions of water and natural gas and have the potential to reduce greenhouse gas (GHG) emissions. However, with the current knowledge relevant to solvent/heat-assisted recovery processes, it still remained uncertain how the in-situ upgrading could impact ultimate recovery and the efficiency of these processes. This study, thus, aims at providing insights about these processes with a numerical model. The study develops a simulation model that captures important mechanisms involved in the processes such as diffusion/dispersion, solvent dissolution, asphaltene precipitation and potential deposition. The complexity of modelling such processes is due to interrelation of oil-gas phase behavior and fluid transport mechanisms combined with in situ upgrading of oil. The intention is not to only identify factors important to the modeling of these processes, but also find how robust simulation models can be developed to replicate observed field behavior. A semi-compositional approach, based on liquid-liquid equilibrium, is proposed to properly capture the asphaltene precipitation in thermal numerical simulators using direct lab measured data. Our analysis will be presented regarding upgrading mechanisms that should be implemented, their effect on the oil production rate, and techniques to model them.

Simulation of Liquid-Liquid Equilibrium in Furfural-Deasphalted Oil Extraction Processes

Simulation of liquid-liquid equilibrium in system of furfural-lubricating oils extraction

An experimental study on optimization utilization of deasphalted oil

Process analysis of the extract unit of vacuum residue through mixed C4 solvent for deasphalting

Simulation and optimization of aromatic extraction from lube oil cuts by liquid-liquid extraction

Simulation and optimization of the extract segment of solvent deasphalting plant

Study on compatibility of DOA and DAO furfural extraction oil in heavy-duty paving asphalt blending

Heavy Petroleum Supercritical Fluid Deasphalting Process Simulation Based On the Saturate, Aromatic, Resin, and Asphaltene Composition

Studies on Pretreatment of Catalytic Cracking Slurry Oil with Added Furfural

Desulfurization of Fluid Catalytic Cracking Diesel Oil by Extraction with Furfuryl Alcohol

Development of correlations between deasphalted oil yield and Hansen solubility parameters of heavy oil SARA fractions for solvent deasphalting extraction

Catalytic cracking performances of dao and its raffinate oils from furfural extraction

Optimization of vacuum resid solvent deasphalting to produce bright stock and hard asphalt

Evaluation on DAO obtained from solvent deasphalting process of vacuum residue blending coal tar based on SEFE

Liquid–Liquid Equilibrium Data and Process Simulation for Separating the Mixture of Decanol + Undecanol + Tetradecane + Pentadecane

Chemical Modification Process of Heavy Residue from FCC Slurry Oil for Producing High-Grade Paving Asphalt

Novel Solvent Deasphalting Process by Vacuum Residue Blending with Coal Tar

Solute Structure Effect on Aromatics-Alkanes Extractive Separation Toward Rational LCO Upgrading

Simulation Study of FCC Light Gasoline Etherification Using a Combined Method

A Semi-Compositional Approach to Model Asphaltene Precipitation and Deposition in Solvent-Based Bitumen Recovery Processes

Simulation of multiphase behavior in supercritical CO2–heavy oil–water sludge extraction systems using cubic-plus-association equation of state