Abstract:Silicone rubber (SR) is high-voltage insulator, but suffers from poor mechanical properties. Nanoparticle addition is a promising way to combat this problem. Herein, SiO2, Al2O3, MgO, SiC and thermally modified SiC nanoparticles were used to improve electrical resistivity, thermal stability and mechanical properties of SR. Surprisingly, electrical resistivity of SR was enhanced by one-order-of-magnitude by incorporation of small amount of nanoparticles, which induced nano-scale traps to capture charge carriers and restrict SR molecules conformation. Tensile strength and modulus of SR increased by SiO2, Al2O3, MgO and SiC incorporation, while decreased elongation at break, as a consequence of agglomeration as detected by microscopic observations. Nano fillers restricted the motion of polymer chains, so storage modules and hardness were increased. Addition of 2 phr SiC resulted in less polarization current comparably. Correspondingly, dielectric breakdown strength of the assigned sample was increased. SiC thermally modified interface is more conductive than the other parts of the matrix reduced charge accumulation and provide more conductive ways for increased charge carriers mobility, dissipate more charges and then increased dielectric breakdown strength. Dynamic-mechanical-thermal analyses demonstrated that storage modulus of SR nanocomposites was comparatively higher than neat SR, owing to rigidity contributed from SiO2 and SiC nanoparticles. Evidently, glass transition temperature shifted to a higher temperature (−109°C) compared to the neat SR (−127°C). Thermogravimetric analysis witnessed superiority of thermal stability of nanocomposites compared to SR, featured by 35°C rise in degradation temperature. The presence of nanoparticles in the polymer matrix acts as a barrier and prevents the release of gaseous products from burning and the entry of oxygen into the system lead to increase thermal stability.

Preparation of Nano-silver Coated Al2O3 Particles and the Thermal Conductivity of Nano-silver Coated Al2O3/Silicone Rubber Composites

Effect of Micro-Si3n4-Nano-Al2o3 Co-Filled Particles on Thermal Conductivity, Dielectric and Mechanical Properties of Silicone Rubber Composites

Effect of graphite and its surface modification on thermal conductivity of silicone rubber

Silver Doped Boron Nitride Approach to Improve the Thermal Conductivity of Polyurethane Composites

Preparation of Ag-Al2O3 nano-composites powder

Effects of Al2O3 on Thermal Conductivity of Silicone Rubber

Preparation of branched Al 2 O 3 and its synergistic effect with carbon nanotubes on the enhancement of thermal conductive and electrical insulation properties of silicone rubber composites

Preparation of nanoalumina/EPDM composites with good performance in thermal conductivity and mechanical properties

Sol-gel Preparation of Ag-silica Nanocomposite with High Electrical Conductivity

Fabrication and Thermal Conductivity Improvement of Novel Composite Adsorbents Adding with Nanoparticles

Constructing of strawberry-like core-shell structured Al2O3 nanoparticles for improving thermal conductivity of nitrile butadiene rubber composites

Simultaneously enhance thermal conductive property and mechanical properties of silicon rubber composites by introducing ultrafine Al2O3 nanospheres prepared via thermal plasma

Fabrication and characterization of silver core and porous silica shell nanocomposite particles

Development of silicone rubber-based nanocomposites: nanoparticle selection and performance analysis

Experimental and Theoretical Studies of Effective Thermal Conductivity of Composites Made of Silicone Rubber and Al2o3 Particles

Low dielectric permittivity and high thermal conductivity silicone rubber composites with micro-nano-sized particles

Electrical Properties of High Thermal Conductivity Inorganic Fillers/silicone Rubber Composites

Influence of Nano-silica on Silicone Rubber Coatings for Outdoor Insulation

Fabrication and Characterization of Al2O3-Siloxane Composite Thermal Pads for Thermal Interface Materials

Improving the Thermal and Mechanical Properties of an Alumina-Filled Silicone Rubber Composite by Incorporating Carbon Nanotubes