Abstract:The effect of alkali and alkali earth metals on pyrolysis behavior of tobacco was revealed in this paper. Four alkali and alkali earth metal ions (Na+, K+, Ca2+, and Mg2+) were used to impregnate acid-washed tobacco. The addition of alkali and alkali earth metal ions in acid-washed tobacco increases the relative content of ketones, acids, nitrogen containing compounds, and esters, while inhibit the formation of anhydro sugars and aldehydes. The generation of solid residues is enhanced by the presence of alkali and alkali earth metal ions and the increase of K+ concentration. The addition of 0.5 mmol K+/g can increase the yield of solid residues from 13.7 wt% to 20.2 wt%. The increase of K+ concentration promotes the conversion of anhydro sugars to ketones. The effect of hot water-wash, acid-wash, and acid-infuse, which can control the concentration of alkali and alkali earth metal ions in the tobacco, on the product distribution of tobacco pyrolysis were also discussed. Acid-wash method and hot water-wash method promote the production of carbohydrate derivatives and inhibit the generation of nitrogen-containing products. After nitric acid-wash and hot water-wash pretreatment, the relative content of nitrogen-containing products decreased from 52.1% to 6.2% and 4.3%, respectively. Compared with inorganic acid-wash pretreatment method, organic acid-wash pretreatment method has weaker inhibition on nitrogencontaining products. Organic acid-wash pretreatment method promoted the formation of aromatics and aldehydes. Prewash methods facilitate the thermal decomposition of tobacco. The results from this study suggests that feedstock pretreatment could be used as a strategy of controlling aroma compounds formation from tobacco.

A study on characteristics to wet end chemistry of paper-process reconstituted tobacco

Effect of Different Chemical Treatments on the Dispersion Properties of Carbon Fiber and Paper Properties

Effect of Fixing Agent Dosage on the Mechanism of Colloidal Substances Retention Onto Pulp

Chemical Treatment of Carbon Fibers and the Development of Functional Paper

A study on modification of chemi-mechanical pulping property of wheat straw by pretreatment with ZnCl2aqueous solution

Study of Sizing with Anionic Rosin Emulsion of the Recycled Paper Pulp

Research on Surface Treatment of Carbon Fiber and the Conductive Properties of Paper

ZnCl2 Pretreatment of Bamboo Chips to Produce Chemi-Thermomechanical Pulp: Saving Refining Energy and Improving Pulp Properties

Interfacial Modiﬁcation and Dispersion of Short Carbon Fiber and the Properties of Composite Papers As Gas Diffusion Layer for Proton Exchange Membrane Fuel Cell (PEMFC)

Plasma Treatment for Cellulose in Tobacco Paper-Base: the Improvement of Surface Hydrophilicity and Mechanical Property.

Influence of Alkali and Alkali Earth Metals on Pyrolysis of Tobacco Waste

Effect of Four Types of Adhesives Applied for Rolling Process of Reconstituted Tobacco

Controllable Synthesis of Carboxymethyl Cellulose and Its Application in Tobacco Sheets

Research on Improving Quality of Rolling-process Reconstitution Tobacco

Electrodialytic Desalination of Tobacco Sheet Extract: Membrane Fouling Mechanism and Mitigation Strategies

Screening for Particular Pollutants in Regenerated Papermaking Wastewater and Study of Their Migration and Transformation

Study on the interactions between dissolved and colloidal substances under the treatment of fixing agents in papermaking

Isolation and utilization of tobacco-based cellulose nanofiber (TCNF) for high performance reconstructed tobacco sheet (RTS)

EFFECT OF FIXING AGENTS ON THE AMOUNT OF WET END CHEMICALS ADSORBED ONTO A BLEACHED CHEMITHERMOMECHANICAL PULP

Pyrolysis Behavior of Paper-base of Paper-making Process Reconstituted Tobacco with Different Physical Parameters under Flash Pyrolysis Conditions

Insights into the interfacial transfer impedance behavior of moisture and dynamics of sorption diffusion in dried tobacco leaves surface