Abstract:While using scanning electron microscopy (SEM) to investigate the impact of ovipositing butterflies on the leaf surface, it became clear to us that the complex topography of natural leaf surfaces, including the crystalline structure of surface waxes (as shown in Hallam & Juniper, 1971), makes it difficult to find and recognize marks made by insects. In consequence, we devised a new technique, using an artificial leaf surface, for viewing such marks. Dental wax (Hygenic Extra Tough Base Plate Wax, Pelco Inc. #109) was cut into 1 sq. cm pieces, and one surface of each wax substrate was heated for <2 sec with a propane torch to remove surface imperfections. We then attached the wax substrates to the upper surface of leaflets of potted hostplants, Pastinaca sativa L., by placing a coil of cellophane tape under each wax square. Recently eclosed and mated Papilio polyxenes Stoll females were then allowed to fly freely in a well-lit cage with a potted hostplant. The butterflies began to drum the leaves (tap their forelegs alternately on the leaf surfaces; Ilse, 1937) soon after contacting the plant, occasionally drumming directly on the wax squares. This behavior exposes sensors on the legs of the butterfly (Ma and Schoonhoven, 1973) to phytochemicals at the leaf surface. The wax was removed immediately and stored at 4OC as a precaution against softening. The wax squares were then mounted on aluminum specimen stubs with colloidal graphite. Stubs were sputter-coated with Au/Pd using an EmScope SC500 sputter coater operated at llOV at 10mA. We viewed the specimens with an AMRAY 1OOOB scanning electron microscope operated at an accelerating potential of 1 7 KeV. The value of using dental wax as a viewing substrate is demonstrated in the figures. The dorsal surface topography of a leaf of Pastinacea sativa (Fig. l), a common host of P. polyxenes, reveals complex features that make it difficult to recognize marks made by insects. The control substrate after heating (Fig. 2), on the other hand, presents a relatively smooth surface. In consequence, the impact of drumming on the leaf surface (Figs. 3 & 4) is readily apparent on the wax substrate. The typical drumming pattern consists of one or two puncture marks from the impact of the tarsal claws, followed by a more shallow scraping of the wax surface. These scratches are typically about 1 O p n wide and up to lmm long. The technique described here has proven to be a very rapid and reproducible method to study aspects of insect behavior. The wax substrate is dimensionally stable in the SEM and does not require normal fixation and dehydration procedures. Specimens are prepared typically in a matter of minutes rather than hours. Minimized handling of the samples also reduces the likelihood of loss or change in the marks made by the insects. The technique is limited by technical considerations, however. The electron beam may cause thermal damage if operated at high accelerating voltages. We have observed good results operating our instrument at 1-7 KeV accelerating potential and 5-35 PA beam currents; these operative conditions provide high-resolution, dimensionally-stable images free of charging artifacts. Operation at higher (10-15) KeV resulted in images which exhibited edge effect charging; higher KeV may also cause melting. If charging persists or operation at low KeV is not feasible, imaging with a backscatter detector may provide acceptable results. Also, inappropriate coating procedures may damage the wax surface thermally. Sputter-coating at low voltage produces negligible heat at the specimen surface and so ensures the dimensional integrity of the specimen. Furthermore, we have found that the wax substrate does not produce excessive contamination of the optical column, and specimens stored in a dessicator for more than 2 years show no deterioration. We thank Paul P. Feeny, Cornell University, in whose lab we did the behavioral studies.

Effects of Eatable Gums in Flour Batteron on Quality of Microwave-reheat Popcorn Chicken

[Comment from the infection viewpoint].

Effects of Different Improvers on Frozen Dough and the Quality of Steamed Stuffed Bun

Study on Reduction of Acrylamide in Fried Bread Sticks by Addition of Antioxidant of Bamboo Leaves and Extract of Green Tea.

Effect of Konjac Glucomannan on Structure, Physicochemical Properties, and In Vitro Digestibility of Yam Starch during Extrusion

Appropriate Microwave Improved the Texture Properties of Quinoa Due to Starch Gelatinization from the Destructed Cyptomere Structure

Effect of microwave treatment and water-bath heating treatment on the performance of glutenin from Tiger nut seed meal: Insights into changes in structural characteristics, functional properties, and in vitro gastrointestinal digestibility

Effect of the addition of mung bean, corn, and sweet potato starch on the properties of konjac gel

Effect of common and new gums on the quality, physical, and textural properties of bakery products: A review

Effects of Enzymatic Konjac Glucomannan Hydrolysates on Textural Properties, Microstructure, and Water Distribution of Grass Carp Surimi Gels

Use of dental wax for the study of insect behavior by scanning electron microscopy

Effects of drying treatment-induced changes in the physicochemical properties of starch on the textural characteristics of Ginkgo seed crisps

Evaluation of the effect of basil seed gum, tragacanth gum, pectin, and coating formulation with corn flour on oil absorption and sensory properties of watermelon rind chips

The Effect of Hydrocolloids on Penetration Tests and Syneresis of Binary Gum Gels and Modified Corn Starch–Gum Gels

Effects of Starch Addition on KGM Sol's Pasting, Rheological Properties, and Gel Texture

In-Depth Insight into the Mechanism of Incorporation of Abelmoschus manihot Gum on the Enhancement of Gel Properties and In Vitro Digestibility of Frankfurters

No solutions here. Politicos fail on the economy while forgetting what happened in the past.

The interaction of starch-gums and their effect on gel properties and protein conformation of silver carp surimi

Effect of Konjac Glucomannan on Sensory, Physical and Thermal Properties of Mochi

Effect of carboxylation cellulose nanocrystal and grape peel extracts on the physical, mechanical and antioxidant properties of konjac glucomannan films

Mechanical and Barrier Properties Optimization of Carboxymethyl Chitosan-Gelatin-Based Edible Film Using Response Surface Methodology