Abstract:Extracting energy from hydrate-bearing sediment involves phase change, during which the strength of sediment is reduced and the risk of geohazards may subsequently increase. However, existing mechanical constitutive models cannot capture the responses of hydrate-bearing sediment during phase change since kinetics of phase change is ignored. Besides, most models are not suitable for hydrate-bearing sandy sediment since the dilatancy of sand is not considered well. In the current study, a state-dependent mechanical constitutive model for hydrate bearing sediment considering phase change of hydrate is developed. The bounding surface plasticity is adopted. Fugacity is incorporated into the model to account for phase change of hydrate and the effects of thermodynamic states on mechanical behaviour of hydrate-bearing sediment. Additionally, a non-linear critical state line and a non-associated flow rule are adopted for hydrate-bearing sandy sediment, which is the most favourable for exploitation due to high hydrate content and permeability. These unique features can improve model performance regarding sediment responses during phase change of hydrate. The model is verified by comparing measured results of hydrate dissociation tests, drained triaxial tests and dissociation tests of hydrate-bearing sand. It is evident that stress-strain and volumetric responses of hydrate-bearing sandy sediments can be well captured by this model over a broad range of effective stresses from 0.1 MPa to 5 MPa. Additionally, the responses of hydrate-bearing sediment during dissociation under different stress states have been successfully reproduced. With an initial axial strain of 5%, dissociation of hydrate results in the development of over 20% axial strain and causes the specimen to collapse.

Constitutive Model for Fluid of Post-Liquefied Sand

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Flow Deformation and Cyclic Resistance of Saturated Loose Sand Considering Initial Static Shear Effect

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Energy-based Assessment of Cyclic Liquefaction Behavior of Clean and Silty Sand under Sustained Initial Stress Conditions

Characterizing the Liquefaction Potential and Pore Pressure Generation of Silty Sands Through the Energy-Based Approach in the Framework of Critical State Soil Mechanics

Preliminary Study on Flow Constitutive Model of Post Liquefied Sand in Zero Effective Stress State

Constitutive Model And Its Application Of Flow Deformation Induced By Liquefied Sand

A nonlinear constitutive model for soft clay stabilized by magnesia cement considering the effect of solidified agent content

Constitutive Modeling of Physical Properties of Coastal Sand During Tunneling Construction Disturbance

Comparison of Cyclic Liquefaction Behavior of Clean and Silty Sands Considering Static Shear Effect

A State-Dependent Constitutive Model for Coarse-Grained Gassy Soil and Its Application in Slope Instability Modelling

Soil Dynamic Constitutive Considering Post-Liquefaction Deformation and Reversible Pore-Water Pressure

Liquefaction of Sand under Monotonic and Cyclic Shear Conditions: Impact of Drained Preloading History

Constitutive Model for Sand Considering the Variation of Its Physical State

A Constitutive Model for Evaluating Small to Large Cyclic Strains of Saturated S and During Liquefaction Process

A New Parameter to Evaluate Liquefaction Resistance of Saturated Sand under Complex Dynamic Stress Paths

Hypoplastic model with fabric change effect and semifluidized state for post‐liquefaction cyclic behavior of sand

A State-Dependent Constitutive Model for Gas Hydrate-Bearing Sediment Incorporating Phase Change

A Cyclic Elasto-Plastic Constitutive Model for Evaluating Large Liquefaction-Induced Deformation of Sand

A Basic Constitutive Model for Sands