One-Dimensional Compressibility and Creep Characteristics of Unsaturated Compacted Loess Based on Incremental Loading and Constant Rate of Strain Methods
Pengju Qin,Qingchen Yan,Yu Lu,Chungang Yang,Zhiwei Song,Chunbao Li
DOI: https://doi.org/10.3390/su151813854
IF: 3.9
2023-09-19
Sustainability
Abstract:In engineering practice, unsaturated compacted loess is often utilized as a filling material in the loess regions. The loess inevitably undergoes one-dimensional compressibility and creep deformation due to the long-term effects of the upper soil layers and buildings. When the deformation is large enough, it tends to damage buildings and threaten engineering safety. In this regard, the one-dimensional compressibility and creep properties of unsaturated compacted loess based on incremental loading (IL) and constant rate of strain (CRS) methods have been studied. First, soil materials with an initial moisture content of 15% were prepared and then compacted into soil samples with an 80 mm diameter and a 10 mm height. Second, the compressibility and creep properties of the compacted loess samples obtained via the IL and CRS compression tests were compared and analyzed. In this study, several parameters, including the primary compression index Cc and secondary compression index Cα, were derived. Meanwhile, the moisture content of the samples was measured via electrical resistivity methods. Finally, the microstructural characteristics were derived via nuclear magnetic resonance (NMR) and scanning electron microscopy (SEM) tests. The results showed that Cc and Cα increased with the increase in moisture content and vertical stress; Cα/Cc ranged from 0.026 to 0.042. Compared with the compression parameters and deformation of the samples, those obtained via the CRS tests are a little larger than those obtained via the IL tests for a given loading and initial moisture content. The electrical resistivity depends on pore water-connected channels, which were deeply affected by the initial moisture content, vertical stress and loading duration (or strain rate). Moreover, as vertical stress increased, the pore size and pore area gradually decreased, the coarse particles were broken, and the fine particles increased. The contacts between particles changed from point-to-point contacts and edge-to-edge contacts to face-to-face contacts. Meanwhile, as vertical stress and loading rate increased, the loess particles were apt to vary from irregular elongated particles to equiaxial circular particles. This investigation can provide a theoretical base and experimental support for improving ground stability and preventing landslide disasters in loess regions.
environmental sciences,environmental studies,green & sustainable science & technology