Abstract:The membranes bioreactor filled with modified fillers was used to treat the printing and dyeing wastewater,and its functions in removing the pollutants and reducing the membrane fouling were observed.The results showed that the reactor had a higher removal rate of COD and NH3-N,when the concentrations of influent and effluent COD were 436-1 722 mg/L and 43-79 mg/L,and the concentrations of influent and effluent NH3-N were 160-245 mg/L and 6.6-16.8 mg/L.The removal rates of COD and NH3-N were 88.99%-96.93% and 90.69%-96.94% respectively,and its effluent water quality can reach the second grade criteria of Discharge Standard of Pollutants for Municipal Wastewater Treatment Plant(GB18918-2002).It was found that the membrane filtration resistance increased rapidly at the suction time of 20 min,and the membrane flux could better maintain the stability of membrane filtration performance at the suction time of 15 min.When the membrane flux was11.2 L/(m2·h),the transmembrane pressure showed an upward trend with the extending operation time,and the modified filling contributed the largest to reducing membrane fouling;the variation trend of ρ(MLVSS)/ρ(MLSS) ratio was similar to that of SOUR,the biofilm of system contained high content volatile organic compounds with high activity.Dosing of modified filler can effectively reduce the membrane fouling and greatly extend the membrane cleaning cycle.

Printing Wastewater Treatment by Combined Short Process of Anaerobic Membrane Bioreactor (AnMBR)-Sequencing Batch Reactor (SBR)

[Printing and Dyeing Wastewater Treatment Using Combined Process of Anaerobic Bioreactor and MBR].

Treatment of Printing and Dyeing Wastewater by MBR-NF Process

Treatment Of Printing And Dyeing Wastewater By A Submerged Double-Shaft Rotary Anaerobic Membrane Bioreactor

Treatment of Printing and Dyeing Wastewater with Multi-Strain Bioaugmentation Process of SBR

The Practice and Discussion on the Improvement of the Process for Printing and Dyeing Wastewater Treatment

Dyeing and Printing Wastewater Treatment by Combined Coagulation-Mbr Technology

Study on combined MBR-NF process for treating domestic wastewater and a big shopping mall's wastewater

Performance of Combined Process of Anoxic Baffled Reactor-Biological Contact Oxidation Treating Printing and Dyeing Wastewater

Treatment Effect of Printing and Dveing Wastewater by Modified Filler Enhanced Combined MBR Process

Performance of a Novel HABR–CFASR System for the Biological Treatment of Mixed Printing and Dyeing Wastewater (MPDW)

Treatment of Printing and Dyeing Wastewater by Anaerobic/Anoxic/Aerobic Biological Process

Study on Influencing Factors of Pharmaceutical Wastewater Treatment with SBR

Treatment Efficiency of Different Wastewaters by Inner-support Flat MBR

Treatment of Printed Circuit Board Comprehensive Wastewater by Submerged Membrane Bioreactor

Research of Upgrading and Rebuilding to Printing and Dyeing Wastewater by MBBR

Treatment of printing and dyeing wastewater using MBBR followed by membrane separation process

Study on Dyeing and Printing Wastewater Treatment by a MBR Technology

Experimental study on the treatment of antibiotic pharmaceutical wastewater by pretreatment + SBR + MBR

Advanced Treatment Engineering of Printing and Dyeing Wastewater and Process Improvement

Reconstruction of Printing and Dyeing Wastewater Treatment Process