Abstract:This study investigates the effects of aluminum (Al) and F interactions on the coagulation behaviors of Al salts, i.e., AlCl3 and polymer aluminum chloride (PACl) at different basicity (B) towards fluoride. These coagulants achieve the optimum fluoride removal over pH 6-7, and PACl exhibits higher removal efficiency than AlCl3 does over pH 4-9. The removal of fluoride is positively correlated with the content of either Al-13 or Al-b in Al-based coagulants over pH 4-9 and increases in the order: PACl(2) > PACl(1) > AlC13. As for PACl, the increased B from 0 to 2.4 improves fluoride removal owing to the elevated ratios of Al-b. However, at further increased B to 2.8, the formation of colloidal Al species (Al-c) occurs and this effect adversely inhibits fluoride removal thereafter. The removal of fluoride by these coagulants increases with elevated initial fluoride concentrations ([F](0)) from 0 to 20 mg/L. At high [F](0) of 80 mg/L, fluoride removal by AlC13 decreases to as low as 13.1% owing to the formation of soluble Al-F complexes, as indicated from the high residual Al concentrations of 16 mg/L. Interestingly, this adverse effect can hardly be observed for PACT due to the stronger stability of Al-13 or Al-b. As for AlC13 and PACl, the introduction of fluoride changes the Al species distribution to some extent owing to the Al-F complexation, as indicated by the analysis of electrospray ionization mass spectrometry. The possible Al-F complexes formed fluoride and different Al species are proposed thereafter. PACl with diverse Al species and high Alb or Al-13 content shows higher removal efficiency towards fluoride than AlC13 does, especially at high [F](0) or under acidic pH and alkaline pH conditions. (C) 2016 Elsevier B.V. All rights reserved.

Transformation rule of aluminum form of Al-based coagulants in coagulation and sedimentation process

The Transformation of Aluminium Species in the Processes of Coagulation, Sedimentation and Filtration

Humic acid removal from water with polyaluminum coagulants: Effect of sulfate on aluminum polymerization

A Comparative Study Of Conventional Coagulation And Sludge Recycling Enhanced Coagulation For Low-Turbidity Source Water: The Effect And Applicability

Relative Importance of Hydrolyzed Al(III) Species (ala, Alb, and Alc) During Coagulation with Polyaluminum Chloride: A Case Study with the Typical Micro-Polluted Source Waters

Coagulation Behavior of Aluminum Salts in Eutrophic Water: Significance of Al13 Species and Ph Control

Aluminum Speciation in Polymerized Aluminum Chloride: Roles and Chloride Ion Migration in Sludge Dewatering

Coagulation Behavior of PAC with Different Aluminum Speciation Produced by Electrolysis Process

Effect of Aluminum Speciation and Structure Characterization on Preferential Removal of Disinfection Byproduct Precursors by Aluminum Hydroxide Coagulation.

Chemical characteristics of aluminum aqueous solution and the formation mechanism of aluminum polymer

Coagulation Behaviour of Polyaluminium Chloride with Different Aluminium Speciation

Aluminum formate (AF): Synthesis, characterization and application in dye wastewater treatment

Deposition Behavior of Residual Aluminum in Drinking Water Distribution System: Effect of Aluminum Speciation

Transfer and Transport of Aluminum in Filtration Unit

Coagulation Behaviors of Aluminum Salts Towards Fluoride: Significance of Aluminum Speciation and Transformation

Enhanced Coagulation with Polyaluminum Chlorides: Role of Ph/alkalinity and Speciation.

Role of Aluminum Speciation in the Removal of Disinfection Byproduct Precursors by a Coagulation Process.

[Coagulation Behavior of Al13 Species].

Comparison of aluminum formate and traditional aluminum coagulants in structure, hydrolysates, coagulation behavior, and its corrosion resistance advantage

Effect of aluminum speciation on arsenic removal during coagulation process

Research Progress of Aulminum Disposition and Distribution in Water Supplying System