Effect and mechanism of stabilization of chromium contaminated soils in electroplating factory by sulfide-based stabilizers

Xin LU,Qishi LUO,Fuwen LIU,Manli WANG,Kuangfei LIN,Changzheng CUI
DOI: https://doi.org/10.13671/j.hjkxxb.2017.0028
2017-01-01
Abstract:This study aims to investigate the effects of valance change,leaching toxicity and fraction distribution for stabilization of Cr (Ⅵ) using sulfidebased stabilizers (calcium polysulfide (CPS),sodium sulfide (Na2S) and sodium metabisulfite (Na2S2O5)).The results showed the maximum decrease in Cr (Ⅵ) contents from 1587.5 mg· kg-1 to 12.43 mg· kg-1 was achieved with an efficiency of 99.2% at CPS molar ratio of 3.In comparison,the reduction efficiencies by Na2S and Na2S2O5 under the same condition were 55.6% and 74.5%,respectively.CPS shows the highest stabilization effect to Cr (Ⅵ) and total Cr.At CPS molar ratio of 3,the stabilization efficiency of 99.8% and 99.1% was reached for 0.02 mg·L-1 of Cr (Ⅵ) and 0.32 mg·L-1 of total Cr concentration,respectively.The Cr (Ⅵ) concentration is well below the standard limit (0.05 mg· L-1) specified in GB/T 14848-93.With the same molar ratio of Na2S and Na2S2O5,stabilization efficiency of Cr (Ⅵ) were 63.0% and 98.9% and that of total Cr were 66.5% and 77.2%,respectively.The concentrations of Cr (Ⅵ) and total Cr decreased with increased dosages of CPS and Na2S,while Cr (Ⅵ) concentration decreased but total Cr continued to increase with increased dosage of Na2S2O5.The fraction change of organic matter was little (p > 0.05) but iron and manganese oxides increased significantly (P < 0.05) in soil stabilized by CPS or Na2S.The change of exchangeable content of Cr in soil stabilized by sulfide-based stabilizers was the main reason for the change of total Cr concentration.Based on Cr (Ⅵ) reduction efficiency by three types of sulfide-based stabilizers,stabilization efficiency of Cr (Ⅵ) and total Cr and the exchangeable content of Cr,the best stabilizing effect was observed at CPS molar ratio 3 for the soil contaminated by chromium in electroplating factory.
What problem does this paper attempt to address?