Determination of polycyclic aromatic hydrocarbons in water using solid-phase microextraction with ordered mesoporous carbon coating

Hui JIANG,Jiansheng LI,Xingru HU,Lianjun WANG
DOI: https://doi.org/10.7524/j.issn.0254-6108.2017.06.2016090902
IF: 4.236
2017-01-01
Environmental Chemistry
Abstract:This work reports the preparation of ordered mesoporous carbon (OMC) film supported on stainless steel wires using solvent evaporation-induced self-assembly approach combined with dipcoating technique and its application in solid-phase microextraction (SPME) of polycyclic aromatic hydrocarbons (PAHs) in water samples.The extraction efficiency and the thermal stability of the OMC fiber were investigated.A SPME method based on the OMC coating for the analysis of PAHs in water samples was established.Characterization results of N2 adsorption-desorption and SEM showed the OMC film had a highly ordered mesostructure with a specific surface area of 522 m2· g-1 and a pore volume of 0.36 cm3· g-1.The film was dense and continuous with a thickness of 11 μm.The OMC fiber showed high resistance under thermal conditions.Five PAHs were analyzed by the SPME method using the OMC fiber.The fiber showed wide linear ranges,low detection limits (0.004-0.012 μg·L-1),low quantify limits (0.010-0.025 μg· L-1) and good repeatabilities (3.9%-7.4% for one fiber,6.7%-9.8% for fiber-to-fiber).The extraction efficiency remained unchanged after 80 desorption at 350 ℃.Compared with commercial fibers,the new fiber presented significantly improved extraction efficiencies with good stability at high temperatures.Under the optimum conditions,the OMC fiber was successfully applied to detect five PAHs in two water samples and achieved satisfactory results with the recoveries of 81.3%-92.8% and 89.3%-108.8%
What problem does this paper attempt to address?