Particulate matter emission and deposition characteristics in human respiratory system during waste printed circuit boards heating and disassembling process

Ang JI,Jianbo WANG,Jie GUO,Zhenming XU,Yichen YANG,Yingshun LI

DOI: https://doi.org/10.15985/j.cnki.1001-3865.2017.06.001

2017-01-01

Abstract:There was a large number of electronic components on the surface of waste printed circuit boards(WPCB).From the perspective of efficient recycling of WPCB,it was very important to remove the electronic components on WPCB.The most common way was heating and melting the solder between electronic components and printed circuit board.While large amount of pollutants would released during the heating and disassembling process,and it would cause environmental pollution and harm to the health of workers.In this research,the characteristics of particle size distribution,number concentration and mass concentration were determined experimentally in the process of heating and disassembling WPCB.The deposition characteristics of the particulate matter in human respiratory system were also studied.The results showed that the majority of the particulate in number were fine particulate matter,and the particle number concentration was higher when particle size smaller.Large particles contributed more of particle mass,with the greater the particle size,the higher the particulate mass concentration.During the treatment process,the emission coefficient of the particle number concentration was 3.30×10.5cm.-3,and the emission coefficient of mass concentration was 9.55 mg/m.3.The deposition fluxes of particulate matter inhaled in the respiratory system of the nose and throat,trachea and bronchus,alveolar area was 3.32,1.26×10.-1,1.99×10.-1mg/h,respectively.About 3.65 mg particulate matters was inhaled into the worker's respiratory system every hour.It's necessary to provide protection measures for workers' respiratory system.