Abstract:The moving bed biofilm reactor (MBBR) has certain advantages, such as high wastewater treatment efficiency, low maintenance and operating costs, and simple operation. It has emerged as a valuable option for small decentralized facilities. The filling ratio, aeration mode and aeration intensity are the main factors that affect the performance of MBBRs in wastewater treatment. However, the information that concerns the used criteria that pertain to the process design for the MBBR is not adequate. In this study, a three dimensional computational fluid dynamics (CFD) model was constructed and the maximum error was only 1.98%, which was much smaller than the traditional 2D-CFD model. The filling ratio, aeration mode and aeration intensity of MBBR were optimized by CFD model from the point of view of fluid mechanics. The results show that the fluidization performance of the filling is the best under the one-side aeration mode with 30% filling ratio. The cost-performance ratio of the reactor with 30% filling ratio was 1.53, 25% and 35% filling ratio were only 1.17 and 1.14 respectively. Increasing the aeration intensity could improve the fluidization performance. However, the effect of high aeration intensity on the fluidization performance of the carrier was limited and the energy consumption increased greatly. The results revealed that when the aeration intensity increased from 0.07 min-1 to 0.13 min-1, the proportion of the carrier area increased by 16.56%. The proportion of the carrier area with an aeration rate of 0.20 min-1 was only 4.23%, which is higher than 0.13 min-1. The main factors that control the fluidization of the carrier were the range of the flow zone and the flow velocity of the liquid. Increasing the range of the flow zone could facilitate the flow of the carriers. The critical value of the flow velocity of the liquid in the flow zone was 0.04 m/s. These results could guide the optimization design of the filling ratio and the aeration conditions and provide a theoretical basis for the application of MBBR.

Research on Low Concentration Wastewater Treated by Inner Cycle of Aerobe in Three-phase Bio-fluidized Bed

Improvement of Inner Components in Biological Fluidized Bed Reactors for Wastewater Treatment

Study on Anaerobic Membrane Bioreactor and Its Applications for Wastewater Treatment

Improvement of Brewery Wastewater Treatment by Adding Internal Cycle in Airlift Bioreactor

Research on the Treatment of Landfill Leathate by an External Biological Circulating Fluidized Bed

Analysis on technical structure and operating parameters of membrane bioreactor (MBR) in application

Hydraulic flow pattern and performance of swirling flow anaerobic attached growth film expanded bed bioreactor

Study on batch biological treatment of refinery wastewater in a fluidized bed

Research on domestic wastewater treatment by swing-bed bioreactor

Research on an integrated equipment for removing organic pollutants,nitrogen and phosphorus

CHARACTERISTICS OF WASTEWATER TREATMENT BY A FIXED-BED BIOREACTOR WITH POROUS MICROBIAL CARRIERS

Investigation of an intermittently-aerated moving bed biofilm reactor in rural wastewater treatment under low dissolved oxygen and C/N condition

ADVANCED TREATMENT OF SIMULATED SWINE WASTEWATER BY A MOVING BED BIOFILM REACTOR

Numerical study of hydrodynamic characteristics in a moving bed biofilm reactor

Research on the biofilm formation during the start of external biological circulating fluidized bed

Experiment and research on problem of sludge distribution in AICS process

Micro-Polluted Water Treatment by Biological Contact Oxidation Process: Aeration Mode and Bacteria Community Analysis

[Analysis of novel style biological fluidized bed A/O combined process in dyeing wastewater treatment]

Distributed treatment of domestic wastewater using an integrated equipment. Part-I. Pilot study on the treatment of domestic wastewater by sequencing batch biofilm reactor

Study on Municipal Wastewater Treatment in a Microaerobic Membrane Bioreactor

Study on treatment of chemical plant wastewater by using a integrated anaerobic–aerobic bioreactor