Abstract:With the establishment of the Chinese space station, a series of space science missions will be conducted in its vicinity. One of the extended tasks for the in-orbit service of space station is the formation flying of small satellites centered around the space station. Satellite formations can perform simultaneous three-dimensional observations of the space station, generating three-dimensional images and monitoring and assessing the status of critical components of the space station. The real-time and accurate relative position measurement is one of the key issues in formation flying. It is a fundamental prerequisite for maintaining and reconfiguring formation configurations, collision avoidance and safety assurance. GNSS-based relative positioning is a low-cost and high-precision measurement method, which is not constrained by light, weather, or relative attitude of satellites. This study introduces a novel approach to determine the relative position of satellites based on single-epoch Global Navigation Satellite System (GNSS) carrier phase difference measurements. Unlike traditional methods, the proposed technique eliminates the need for precise ephemeris and clock bias files and does not require historical observation data. The algorithm avoids the complexity associated with full cycle ambiguity jumps, facilitating real-time, high-precision calculations of relative position baseline vectors. Special attention is given to the influence of Geostationary Earth Orbit (GEO) satellites in the BeiDou Navigation Satellite System (BDS), and measures are taken to mitigate their impact on measurement accuracy by adjusting their observation weights. Our newly developed GNSS-based real-time measurement module, designed for high-quality GNSS signal reception and data communication, was tested on terrestrial and simulated low-orbit platforms. Remarkably, over baselines ranging from 10 m to 9.3 km, while traditional pseudorange differential measurements showed errors up to 1.5571 m, our proposed method consistently held errors under 5 cm and ensured computational speeds within 0.1 s per epoch. High-dynamic zero-baseline tests further validated its potential, with errors less than 1 cm. The innovations encapsulated in this work, resonating with the evolving trends of miniaturized and scalable satellites, present a cost-efficient and real-time solution for inter-satellite relative position measurement. This promises a new horizon in satellite formation technology, with future endeavors focusing on on-orbit experiments.

Height-Measure Accuracy of INSAR in Spaceborne Parasitic SAR System and Flying Formation Design

Design of inter-satellite phase interferometer angle measurement system and its precision analysis

Motion Error Analysis And Compensation For Airborne Formation Flying Insar

A High-Precision Target Geolocation Algorithm for a Spaceborne Bistatic Interferometric Synthetic Aperture Radar System Based on an Improved Range–Doppler Model

Analysis on Speed Error for Airborne Formation Flying InSAR

The Impact of Residual Motion Deviations on Forest Height Inversion by SAR Remote Sensing

A Closed-Form Expression Based Height Inversion for SAR Altimeter

Satellite Formation Flying Control by Using Only Angle Measurements

Airborne Short-Baseline Millimeter Wave InSAR System Analysis and Experimental Results

Conceptual Study and Performance Analysis of Tandem Multi-Antenna Spaceborne SAR Interferometry

Speed error compensation method for airborne formation flying InSAR

Real-time high-precision baseline measurement of satellite formation flying based on GNSS

An Effective Space-Borne ISAR High-Resolution Imaging Approach for Satellite On-Orbit Based on Minimum Entropy Optimization

Research on Configuration Constraints of Airborne Bistatic SARs

Normal Physics Model of Aerial Remote Sensing Platform and Systemic Accuracy Assessment Variable Baseline-height Ratio

Accurate Range Modeling for High-Resolution Spaceborne Synthetic Aperture Radar

Airborne Platform Three-Dimensional Positioning Method Based on Interferometric Synthetic Aperture Radar Interferogram Matching

Formation Design for Single-Pass GEO InSAR Considering Earth Rotation Based on Coordinate Rotational Transformation

Digital terrain, surface, and canopy height model generation with dual-baseline low-frequency InSAR over forest areas

Conceptual Study and Performance Analysis of Tandem Dual-Antenna Spaceborne SAR Interferometry

Forest Height Estimation Approach Combining P-Band and X-Band Interferometric SAR Data