Abstract:The regenerative cooling channel is curved due to the unique structural form of the combined nozzle of the turbine-based combined cycle engine for hypersonic flight. Research on the flow and heat transfer characteristics of fuel in the parallel bending cooling channels is insufficient, which causes difficulties in properly designing the thermal protection structure of the combined nozzle. This paper numerically investigated of the flow and heat transfer characteristics of hydrocarbon fuel RP-3 under non-uniform heating conditions in parallel bending cooling channels. The basic heat flux is 0.50 MW/m 2 , and the heat flux ratio of the upper and lower channels is 1.2, 1.5, and 2.4 respectively. The heat transfer and flow distribution mechanisms of RP-3 in parallel bending channels are revealed. The bending structure is beneficial to reduce thermal stratification and prevent heat transfer deterioration caused by buoyancy. In the pseudo-critical region of the channel, a "thermal insulation zone" is formed due to the low thermal conductivity of RP-3, which hinders the transfer of heat to the mainstream and causes heat transfer deterioration. When the fluid temperature is below 455 K, viscosity is the primary factor affecting the flow resistance difference between parallel channels. As the temperature further increases, the density difference and velocity difference between the parallel channels dominate in the flow resistance differences. Additionally, a connected hole structure in the middle of the bending section has been applied to optimize the flow deviation of parallel bending channels, which promotes the secondary distribution of flow. Finally, the influence mechanism of the connected hole on flow distribution has been studied under different heat flux ratios and connected hole widths.

Research on Thermal Protection of Pylon in RBCC

Numerical investigation on thermal behaviors of active-cooled strut in RBCC engine

Asymmetric Heating and Buoyancy Effects on Heat Transfer of Hydrocarbon Fuel in a Horizontal Square Channel at Supercritical Pressures

Effect of area ratio and heat release method on the Ma∞ = 2-6 operation performance of rocket-based combined cycle engine

Design and Heat Transfer Characteristics Analysis of Combined Active and Passive Thermal Protection System for Hydrogen Fueled Scramjet

Research on the flow and heat transfer characteristics of RP-3 and structural optimization in parallel bending cooling channels

Conjugate Heat Transfer, Endothermic Fuel Pyrolysis and Surface Coking of Aviation Kerosene in Ribbed Tube at Supercritical Pressure

Large Eddy Simulations of Heat Transfer and Thermal Oxidative Coking of Aviation Kerosene in Vertical U-Tube at a Supercritical Pressure

Simulation and Application of a New Multiphase Flow Ablation Test System for Thermal Protection Materials Based on Liquid Rocket Engine

Influence of plasma-enhanced combustion on RBCC engine using URANS

Study on Combined Thermal Protection Scheme Integrating Supercritical CO2 Regenerative Cooling and Fuel Film Cooling Used for Scramjet Engines

Effect of Primary Rocket Jet on Thermodynamic Cycle of RBCC in Ejector Mode

Numerical Investigation on Actively Cooled Thermal Protection Systems with Ni-Based Alloys

Two-stage fuel injection performance of RBCC under scramjet mode

Experimental study on the thermodynamic characteristics of the high temperature hydrocarbon fuel in the cooling channel of the hypersonic vehicle

Numerical study on enhanced heat transfer and flow characteristics of supercritical hydrogen rocket engine's chamber wall using cylindrical ribs structure

Experimental study on ejector-to-ramjet mode transition in a divergent kerosene-fueled RBCC combustor with low total temperature inflow

Numerical study on throttling characteristics of RBCC engines in ejector mode

The numerical and experimental study on characteristics of local heat transfer enhancement for the high pressure thrust chamber

Effect of the heat release on ejector-to-ramjet dynamic mode transition process in the rocket-based combined cycle engine

Integrated Thermal Management Method of Energy Based on Closed Brayton Cycle for Scramjet