Abstract:The clearance flow of compressor variable stator vanes has a significant impact on compressor performance. Most clearance flow experimental research work has been carried out in compressor cascades with lower turning angle (lower load). The clearance flow in a higher load compressor cascade is relatively more complicated due to three-dimensional (3D) flow separation. In the present work, the effects of different heights and locations of clearances in a compressor cascade on aerodynamic performance and separation flow were investigated experimentally in a low-speed plane cascade wind tunnel. The objective of this investigation is to study the characteristics of different clearance configurations depending on the clearance height and the clearance axial position, and make an attempt to verify the possibility of a local clearance flow that improves the performance. The cascade outlet section aerodynamic parameters were measured by L five-hole probe. The ink-trace flow visualizations on the cascade surface and lower end wall were performed. The results show that with the increase in clearance size, the core area of high loss is moving to the end wall and the morphology of limiting streamlines on the suction surface changes gradually from separation lines to reattachment lines. The separation lines on end wall gradually moved to the middle of the cascade and the separation area increased gradually. The above reasons caused high loss zone gradually extended to the end wall. Thus, the loss at mid-span declined slightly while the loss on the end wall was increasing. Otherwise, cascade load reduced significantly when the clearance height became 3mm, and the change magnitude of limiting streamline morphology in the flow field which was influenced by clearance flow at the rear of the blade reached to a minimum. So the loss and load came to a minimum, respectively. The impact of the clearance in the rear of a blade on loss and flow is weaker than the other schemes, with a slightly larger loss and separation with respect to the original scheme without a clearance. It may be expected to improve the cascade performance further by an appropriate design of clearance near the trailing.

Mechanism Study of End-Wall Fillet's Influence on Performance and Flow Field of High-Load Compressor Cascade

Study on Flow Structure of a Highly-Loaded Compressor Cascade Designed with Active and Passive Flow Control Methods

Optimization Design of Variable Fillet for Different Boundary Thicknesses in a Highly Loaded Compressor Cascade

Loss reduction in an ultra-high-loaded low pressure turbine cascade by a combined flow control strategy

The Impact of Variable Fillets on Corner Separation in a Liner Compressor Cascade

Effect of Leading Edge Little Blade on Performance of Highly Loaded Compressor Cascades

Numerical Study On End-Wall Flow In Highly Loaded Supercritical Compressor Cascades

Numerical Simulation of Effect of Blade End Slot on Performance of Compressor Cascade

Oil Flow Visualization and Numerical Calculation on End-Wall of Aspirated Compressor Cascade

Extraction of Geometric Features and Analysis of Flow Mechanism of High Loaded Compressor Airfoils at Low Reynolds Number

Study on Optimization Design and Flow Control Mechanism of Little Blades in a Compressor Cascade

The effect of different clearance geometry configurations on aerodynamic performance in a high-load compressor cascade

INVESTIGATION OF SEPARATION AND FLOW FILED STRUCTURE IN HIGH-LOADING COMPRESSOR CASCADES

Flow quality improvement of the wind tunnel testing for a highly-loaded compressor cascade at high incidence

Effects of endwall boundary layer suction position on the flow field and load in a high-turning compressor cascade

Numerical and Experimental Study on Flow Loss Reduction Effect of Micro-Textured Surface on Compressor Cascade

Non-Axisymmetric Endwall Contouring in a Linear Compressor Cascade

Experimental Investigation of Near-Wall Flow and Flow Loss in Compressor Cascades with Slots Injection

Analysis of Leakage Flow and Loss in a Linear Compressor Cascade with Moving Endwall

Combined Flow Control with Full-Span Slot and End-Wall Boundary Layer Suction in a Large-Camber Compressor Cascade

Application Study of Concave Axisymmetric Endwall Molding in a Compressor Cascade with High Stagger Angle