Abstract:Abstract The present article numerically investigates the design space of an axial, low-speed compressor stage using tandem and single aerofoil configurations. The investigated rotor and stator designs follow a coupled throughflow and blade-to-blade design approach and will yield quasi-3D designed compressor stages with either single-rotor single-stator or tandem-rotor tandem-stator configurations. In past studies, tandem aerofoil configurations have shown a potential for increasing stage working coefficients, while maintaining their efficiency compared to their single aerofoil reference configuration. However, it was also shown that tandem configurations are able to reduce efficiency due to an increase of secondary flow caused by the higher loading and introduction in the second aerofoil. Currently, there is no clear design guideline on when tandem aerofoil configurations should be preferred over single ones, and under which circumstances they should be avoided. To answer this question, the present article will attempt to create a “Smith chart” for tandem aerofoil stages and compare them to their single aerofoil counterparts. Originally intended for use with turbine stages, the Smith chart maps out the potential efficiencies of turbomachinery designs. It plots the working coefficient (Ψ) over the throughflow coefficient (φ), which gives a direct indication of the shape of velocity triangles in the stage. However, the Smith chart has been well investigated for single aerofoil stages, both numerically and experimentally, as well as for low- and high-speed applications, and this is not the case so far for tandem configurations. The current work presents a fast Q3D design and analysis procedure used on a low-speed axial compressor stage and will yield quasi-3D efficiencies for a large number of different design coefficients. The findings of this work will enable future research to identify preferred combinations of design coefficients for tandem aerofoil configurations, which can then be further analyzed in 3D investigations at a higher fidelity level.

Aerodynamic Design Method of High Loaded Supersonic Axial-Compressor with Low Reaction

A throughflow-based optimization method for multi-stage axial compressor

Research on the Flow Path Design Method of Axial Flow Compressor of Gas Turbine

Aerodynamic Design Optimization Of The Last Stage Of A Multi-Stage Compressor By Using An Adjoint Method

Development of A Throughflow Method for Aerodynamic Analysis of Highly Loaded Axial Flow Compressors

Optimal Design and Analysis of a High-Load Supersonic Compressor Based on a Surrogate Model

Design And Test Of A Novel Highly-Loaded Compressor

Design and Performance Analysis of a Two-Stage Transonic Low-Reaction Counter-Rotating Aspirated Fan/compressor with Inlet Counter-Swirl

Development and application of a throughflow method for high-loaded axial flow compressors

Aerodynamic Analysis of a Highly Loaded 5-Stage Axial Compressor

3-D viscous numerical investigation on the overall aerodynamic performance of a transonic axial-flow compressor stage

Aerodynamic Analysis and Three-Dimensional Redesign of a Multi-Stage Axial Flow Compressor

Numerical investigation of boundary layer suction on certain highly loaded aspirated compressor at low speeds

A Novel Airfoil Design Method and its Application to the Optimization Design of a 3-Stage Transonic Compressor

Analytic Method for Computing Axial-flow Compressor and Turbine Characteristics

Aerodynamic Design Method and Experimental Investigation of a High-Load Supersonic Compressor Cascade

Three-Dimensional Aerodynamic Optimization Of A Multi-Stage Axial Compressor

Design of High Specific Speed Mixed Flow Micro-Compressor for Co-Flow Jet Actuators

Aerodynamic Redesign of A 5-Stage Axial Compressor by Restagger and Bow

A Numerical Design Space Investigation of Low-Speed Axial Compressor Stages Using Single-Row and Tandem Bladings