Experimental Study of Flow Resistance and Heat Transfer in Rotor-Stator Cavity for High Pressure Turbine

Lei WANG,Guang-lu HAN,Xiang LUO,Xiao YU,Yi LI
DOI: https://doi.org/10.13477/j.cnki.aeroengine.2017.02.016
2017-01-01
Abstract:In secondary air system of aeroengine,flow and heat transfer problems of turbine disc system usually appear with complex geometry,flow and thermal boundary condition.The flow distribution and heat transfer characteristics are of great importance to the engine design.The experimental investigations of flow resistance and heat transfer in a rotor-stator cavity with pre-swirl inlet nozzles and two outlets at both low radius and high radius were performed.Transient thermochromic liquid Crystal (TLC) technique was employed to measure the convective heat transfer coeffcient on the test surface of the rotating disk.Experiments were carried out with rotational Reynolds number (Reφ) varying from 8×105 to 1.0×106 and dimensionless flow rate (Cw) ranging from 5.29×103 to 1.19×104.Experimental results show that the characteristics of the pressure loss coefficient between inlet and outlet depends strongly on Cw and Reφ.The heat transfer in all the conditions on the rotating disk is strengthened with the increase of the radius of disk as well as the high pre-swirl ratio (βp).The turbulence flow parameter(λr) of outlet has little influence on the heat transfer.
What problem does this paper attempt to address?