Abstract:Selective catalytic reduction (SCR) is a crucial technique for mitigating nitrogen oxides emission of internal combustion engines. Compared with vanadium-based catalysts, copper-based molecular sieve catalysts exhibit superior low-temperature catalytic performance and anti-aging properties. The catalytic characteristics of Cu-SSZ-13 catalyst in both fresh and aged states are investigated through experimental and numerical simulations. The catalytic performance of Cu-SSZ-13 catalyst with 200 g/L coating is investigated under wide inlet temperatures (180 °C–450 °C) and ANR (ammonia to nitrogen ratio) (1–1.4) conditions via an engine emission test device. Further, the apparatus is adopted to evaluate performance at various aging temperatures (600 °C, 700 °C, and 800 °C). The aging factor is introduced based on experimental results to establish and correct the kinetic model for SCR aging state. The results illuminate that the increase of ANR fails to compensate for decline of catalytic efficiency under low-temperature conditions (150 °C).The generated quantity of isocyanate acid through the side reaction of urea hydrolysis increases proportionally with ANR. And it increased supply only resulted in a marginal 1 %–3 % improvement of catalytic efficiency. As SV decreases from 60,000 h −1 to 35,000 h −1 , the catalyst efficiency increases from 22 % to 45 %, resulting in an elevation of reactant concentration and its gradient on the catalyst surface. This leads to accelerated reaction rates and enhanced diffusion effects. The catalytic efficiency can be significantly enhanced at low temperatures when NO 2 fraction in NOx falls within the range of 10 %–25 %. The sensitivity of SCR reactions to aging varies at low temperatures (<250 °C) due to the distinct reaction sites on catalyst for different types of SCR reactions. The NO 2 SCR reactions exhibit minimal susceptibility, while the rapid SCR reactions are significantly impeded. Moreover, it has been observed that the catalyst microstructure was completely deteriorated under hydrothermal aging test at 900 °C operating condition. In general, the low-temperature catalytic performance of Cu-SSZ-13 catalyst can be further optimized by pretreating inlet gas components and optimizing the catalyst structure.

Experimental study on rapid aging test method of standard bench cycle (SBC) for three way catalytic converter

Investigation of the Physicochemical Properties of Soot Subjected to Non-Catalytic and CeO2-catalytic Aging under Sequential Aerobic and Anaerobic Exhaust-Like Conditions Simulating the Transition from Engine Operation to Cessation

Development of the Control and Acquisition System for a Natural-Gas Spark-Ignition Engine Test Bench

Multi-stage Rapid Aging Mode for Durability Evaluation of Automotive Catalysts

Accelerated aging for after-treatment devices of diesel engine: Method, emission characteristics, and equivalence

Experimental study on the performance and diagnosis of hydrothermally aged selective catalytic reduction over a copper-based catalyst

Experimental and numerical study of Cu-SSZ-13 SCR system for NOx reduction and hydrothermal aging under diesel exhaust conditions

Key design and layout factors influencing performance of three-way catalytic converters: Experimental and semidecoupled numerical study under real-life driving conditions

Study on Three-Way Catalyst Deterioration Diagnosis Based on Oxygen Storage Rate Model

Experimental Study on the Catalytic Convert of Automobile Exhaust

A Study on Cold Start Emission Characteristics of Gasoline Vehicle Based on Engine Test Bench Simulation

An analysis of SCR reactor deactivation impact on NOx emissions from a compression ignition engine

Fuel Consumption and Emission Reduction for Non-Road Diesel Engines with Electrically Heated Catalysts

Modeling of a DOC SCR-F SCR Exhaust Line for Design Optimization Taking Into Account Performance Degradation Due to Hydrothermal Aging

An Experimental Study on the Emission Characteristics in CI Engine using Nano Particle Coated Catalytic Converter

Investigation of the physicochemical properties of soot subjected to non-catalytic and CeO 2 -catalytic aging under sequential aerobic and anaerobic exhaust-like conditions simulating the transition from engine operation to cessation

Experimental Investigation of Unsteady Temperature Field s of Automotive Catalytic Converters

Simulation of the flow field and the chemical reaction coupling of selective catalytic reduction (SCR) system using an orthogonal experiment

Effect of different exhaust parameters on conversion efficiency enhancement of a Pd–Rh three-way catalytic converter for heavy-duty natural gas engines

Dynamic evaluation of environmental impact for three-way catalytic converter with temporal variation life cycle method

Decelerating catalyst aging of natural gas engines using organic Rankine cycle under road conditions