Abstract:The aim of this work was to study the buckling behavior and failure mode of the double-sided laser-welded Al–Li alloy panel structure under the effect of axial compression via experimental and numerical simulation methods. In the test, multi-frequency fringe projection profilometry was used to monitor the out-of-plane displacement of the laser-welded panel structure during the axial compression load. In addition, the in-plane deformation was precisely monitored via strain gauge and strain rosette. The basic principles of fringe projection profilometry were introduced, and how to use fringe projection profilometry to obtain out-of-plane displacement was also presented. Numerical simulations were performed using the finite element method (FEM) to predict the failure load and buckling modes of the laser-welded panel structure under axial compression, and the obtained results were compared with those of the experiment. It was found that the fringe projection profilometry method for monitoring the buckling deformation of the laser-welded structure was verified to be effective in terms of a measurement accuracy of sub-millimeter level. The structural failure was caused by local buckling of the skin. The observed failure modes such as local buckling of the skin, bending deformation of the stringers, continuous fracture of several welds, and failure of local strength and stiffness were attributed to the deformed laser-welded panel structure under the axial compression. The predicted failure load in the numerical simulation was slightly smaller than that of the experimental test, and the error of the simulation result relative to the test result was −2.7%. The difference between them might be due to the fact that the boundary and loading conditions used in the FEM model could not be completely consistent with those used in the actual experiment.

Experiment and numerical analysis on the stability of metal corrugated sandwich beams under compression loads

Experimental and numerical investigation on the ultimate load carrying capacity of metal corrugated sandwich beams under four-point bending loads

In-Depth Study on Buckling and Wrinkling of Foam-Cored Sandwich Beam under Uniaxial Compression Load

Experiments and Analysis on Stability of the Sandwich Structures with Soft Core

Experimental Research On Load-Carrying Capacities Of Composite Wall System With High-Strength Cold-Formed Thin-Walled Structures Subjected To Compression And Bending Load

Local Buckling of Compression Flanges of H-Beams with Corrugated Webs

Experimental and Numerical Investigations on Laser-Welded Corrugated-Core Sandwich Panels Subjected to Air Blast Loading

Experiment and Numerical Simulation for the Compressive Buckling Behavior of Double-Sided Laser-Welded Al–Li Alloy Aircraft Fuselage Panel

THE BUCKLING ANALYSIS OF SANDWICH COLUMNS REINFORCED BY METALLIC TUBES

Failure analysis of adhesively bonded steel corrugated sandwich structures under three-point bending

Theoretical and numerical analysis of buckling stability of bi-directional corrugated sandwich panels

Large Deflection Of A Pin-Supported Slender Geometrically Asymmetric Sandwich Beam Under Transverse Loading

Buckling Response of Metallic Foam Composite Sandwich Panels Subjected to Edgewise Compression

Ultimate Strength Behavior of Laser-Welded Web-Core Sandwich Plates under In-Plane Compression

The Load-Carrying Capacity of Sandwich Beams in Different Collapse Mechanisms

Compressive Local Buckling of Integrated Fluted-Core Sandwich Composite Panels

Stability and initial post-buckling of a standing sandwich beam under terminal force and self-weight

Quasi-static Compressive Behavior of U-type Corrugated Cores Sandwich Panels

Buckling of Sandwich Wide Columns

Analysis of deformation and failure mechanism of sandwich beams with lattice core under three-point bending load

The Failure Behavior of Double-Layer Metal Foam Sandwich Beams under Three-Point Bending