Structure Layout and Modification of a Middle Seat Based on the New Regulation on Safety-belt Anchorage Point

Pengcheng Guo,Congchang Xu,Zhiwen Liu,Xiangdong Fang,Luoxing Li

DOI: https://doi.org/10.19562/j.chinasae.qcgc.2017.02.004

2017-01-01

Abstract:In view of that state regulation GB 14167—2013 "Safety-belt anchorages,…" requests all seats in vehicle being equipped with three-point safety belt, leading to the increases in mass and loads born by seat, the seat structure modification and lightweighting are conducted on a M1 vehicle in this paper. Firstly the modeling and simulation are performed on the regulation test on the safety belt anchorage points of single seat and the results show that the maximum forward displacement at the upper anchorage point of middle seat safety-belt reaches 433mm, go-ing through RC plane, failing to meet regulation requirements. Thus a structure modification scheme based on force transmission is implemented resulting in an increase of seat mass of only 0. 18kg, but the maximum forward dis-placement at anchorage point reducing to 104. 3mm and the maximum strain decreasing to 0. 163 from 0. 56, meet-ing regulation requirements. Then the single seat meeting regulation requirements is incorporated into body-in-white and a corresponding simulation results in the maximum forward displacement at anchorage point and strain increasing to 220. 9mm and 0. 198 respectively, still meeting regulation requirements. Furthermore, a lightweighting scheme is proposed by using sensitivity and strain analyses and proceeded with a result showing that the seat mass reduces by 1. 95kg while the maximum forward displacement at anchorage point rises by only 10. 4mm. Finally a validation test is carried out and the results indicate that the simulation results are well agree with test ones, specifically their difference in the maximum forward displacement at anchorage point is only 8. 7mm and the deformation mode and magnitude of the front and rear supporting legs, two lower anchorage points of safety belt and rear floor are close to that of test.