Abstract:International emission tests (EPA, SFTP, MVEG-B, J-10.15, etc.) are carried out with vehicles running on the rolls dynamometer. Results, in terms of total emissions, are influenced by vehicles parameters such as mass, gear ratios, front surface, drag coefficient, etc. It would be useful, in the automobiles design phase, to have information about the impact of these parameters on total emissions. The obvious solution would be to build up a complete vehicle model to simulate performance and emission levels. Engine pollutants production modeling is the weak point, since it is difficult to obtain reliable results. Anyway it is possible to avoid pollutants production simulation, testing the actual engine under the same operating condition it would face inside the car’s hood. This paper describes a methodology whose aim is to test the engine on a standard test bench, simulating on-board operating conditions. An equivalence condition has to be satisfied in order to guarantee the methodology effectiveness: engine speed and Manifold Absolute Pressure (MAP) must always match for the two types of test performed on the same driving cycle. Engine speed and torque can be controlled through the bench actuators, their values depending on the simulated vehicle motion: once the car dynamics are simulated by means of a model, engine speed and torque corresponding to the given driving cycle can in fact be evaluated. The model is solved in real time, its output being the brake load torque value satisfying the equivalence condition. The brake controller, used as a slave, regulates the engine operating conditions consequently. The global model incorporates tires, aerodynamic forces, clutch, gearbox and driveline behaviors simulation: its response has been first validated comparing its outputs with data measured on board, and then it has been used to control an eddy current brake, for vehicle test simulation on the test bench. Two different control philosophies can be used: either a human driver or an automatic controller can ride the simulated car. The influence of vehicle parameters and gearshift mode on fuel consumption and pollutant emissions can be investigated.

A Study on the Bench Test of Brake Pedal Feel for Passenger Car

Evaluation and analysis of comprehensive performance of a brake pedal based on an improved analytic hierarchy process

An Experimental Study on Hysteresis Characteristics of a Pneumatic Braking System for a Multi-Axle Heavy Vehicle in Emergency Braking Situations

Loading Design for Comprehensive Performance Test Bench of Drive Axle Assembly

Design and Improvement of Brake Pedal Feel Emulator in Electro-Hydraulic Brake System

Double-Drum Test Bench for Variable Load Transfer Simulation by Electromechanical Inertia Compensation

Development and Control of a Magnetorheological Damper-Based Brake Pedal Simulator for Vehicle Brake-by-Wire Systems

Design and Development of a Brake Test Bench for Formula SAE Race Cars

Design, modeling, and verification of a test bench for braking simulation of 1/4 vehicle

Research on Performance Test Method of Integrated Electro-Hydraulic Braking System

The Development of Dynamic Test Bench for EV Hybrid Brake System

Test Bench Emulation of Slip Ratio During Anti-Lock Braking of Electric Vehicle

A Study on the Hybrid FE-experimental Analysis Method for Dash Panel Response Excited by the Brake Booster Based on BF-TPA

An Analysis on Control Method of the Brake Test Bench

Development of a Test Bench for Automobile Seating Comfort Evaluation

Comfort Analysis on Anti-Lock Braking System Based on High-Speed Switch Valve

Study on a Testing Device of Automobile Brake Drum Running-In and Braking Force

Testing Passenger Car Brake Pad Exploitation Time’s Impact on the Values of the Coefficient of Friction and Abrasive Wear Rate Using a Pin-on-Disc Method

The Measurement for Performance Parameter of Automobile Braking System with Electronic Vacuum Booster

Vehicle Simulation on the Test Bench

A Novel Regenerative Electrohydraulic Brake System: Development and Hardware-in-Loop Tests