Abstract:A novel plasma-driven catalysis (PDC) reactor with special structure was proposed to remove vehicle exhaust gas. The PDC reactor which consisted of three quartz tubes and two copper electrodes was a coaxial dielectric barrier discharge (DBD) reactor. The inner and outer electrodes firmly surrounded the outer surface of the corresponding dielectric barrier layer in a spiral way, respectively. Nano-titanium dioxide (TiO2) film prepared by radiofrequency (RF) magnetron sputtering was coated on the outer wall of the middle quartz tube, separating the catalyst from the high voltage electrode. The spiral electrodes were designed to avoid overheating of microdischarges inside the PDC reactor. Continuous operation tests indicated that stable performance without deterioration of catalytic activity could last for more than 25 h. To verify the effectiveness of the PDC reactor, a non-thermal plasma(NTP) reactor was employed, which has the same structure as the PDC reactor but without the catalyst. The real vehicle exhaust gas was introduced into the PDC reactor and NTP reactor, respectively. After the treatment, compared with the result from NTP, the concentration of HC in the vehicle exhaust gas treated by PDC reactor reduced far more obviously while that of NO decreased only a little. Moreover, this result was explained through optical emission spectrum. The O emission lines can be observed between 870 nm and 960 nm for wavelength in PDC reactor. Together with previous studies, it could be hypothesized that O derived from catalytically O-3 destruction by catalyst might make a significant contribution to the much higher HC removal efficiency by PDC reactor. A series of complex chemical reactions caused by the multi-components mixture in real vehicle exhaust reduced NO removal efficiency. A controllable system with a real-time feedback module for the PDC reactor was proposed to further improve the ability of removing real vehicle exhaust gas.

Development of Cold Plasma-Catalytic Reactor for Exhaust Purification and Experimental Research

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Vehicle Exhaust Gas Clearance By Low Temperature Plasma-Driven Nano-Titanium Dioxide Film Prepared By Radiofrequency Magnetron Sputtering

Non-thermal Plasma Generation by Using Back Corona Discharge on Catalyst

Characteristics of Back Corona Discharge in a Honeycomb Catalyst and Its Application for Treatment of Volatile Organic Compounds.

Optimization for Plasma-facilitated Catalytic Reduction of NO_x

Research on Lean NO_x Removal by Plasma Enhanced Selective Catalytic Reduction over InZSM-5

Low temperature plasma-driven catalysis of nanotitanium dioxide for vehicle exhaust clearance

Synergy Study for Plasma-Facilitated Catalytic Reduction of NOx

Role of Nitrogen-Containing Organic Compound in Plasma Exhaust Treatment

Combination of Nonthermal Plasma and Low Temperature-C3h8-Selective Catalytic Reduction over Co-In/H-Beta Catalyst for Nitric Oxide Abatement

A Novel Four-Way Plasma-Catalytic Approach for the after Treatment of Diesel Engine Exhausts

Research progress on the preparation of transition metal-modified zeolite catalysts and their catalytic performance for the purification of engine exhausts

Cold plasma catalytic reaction

Scale-up Experiment of Plasma Reactors with Different Electrode Structure

Sustainable Removal of Particulate Matter from Diesel Engine Exhaust at Low Temperature Using a Plasma-Catalytic Method

Cold plasma treatment of catalytic materials: a review

An investigation of the treatment of particulate matter from gasoline engine exhaust using non-thermal plasma

High-efficiency Removal of NOx Using a Combined Adsorption-Discharge Plasma Catalytic Process.

Non-thermal plasma coupled with CM/Z5 catalyst for toluene removal

A two dielectric barrier discharge devices for exhaust -gas treatment has a catalytic coating