Abstract:Due to the rapid development of the distribution network, there is an urgent need for high-precision state estimation and safe and stable operation, this paper proposes a joint optimal placement method for Phasor Measurement Unit (PMU) and Dual Use Line Relay (DULR) in distribution networks considering fault reconstruction and state estimation accuracy. The proposed method aims to minimize the cost of PMU and DULR configuration. Based on the known pseudo-measurements and Supervisory Control and Data Acquisition (SCADA) measurements, we use the E-optimal standard design of the state estimation error covariance matrix to form the state estimation accuracy index and take the relay protection function of Feeder Terminal Unit (FTU) device and DULR device into consideration of the fault reconstruction. By solving the mixed integer semidefinite programming (MISDP) model, the optimal placement result is obtained, so that the network under normal condition and the network after multiple fault reconstruction can meet the constraints of state estimation accuracy and load loss rate respectively. The proposed method is tested on IEEE 33-node, 123-node systems as an example. The experimental results show that the proposed method is effective and practical. Note to Practitioners— This study is stimulated by the need for optimizing the placement of Micro-PMU (μPMU) in distribution network. Since the new μPMU device DULR has the same relay protection function as FTU, and distributed generation can supply power to the island after failure, this paper adds the load loss rate to the constraint conditions to study the influence of fault reconstruction on the placement scheme. A new two-step SE method considering mixed measurements was used in this paper to improve the computational efficiency of real-time SE of large-scale system while ensuring the accuracy of the calculation results. We have conducted tests in IEEE-33 and IEEE-123 systems. After preliminary verification, compared with the single fault scenario, we find that the placement scheme considering multiple fault scenarios can effectively improve the accuracy of state estimation and reduce the load loss rate of each fault scenario and only increase the cost a little. The increase in the number of DG and contact lines in the network will also effectively improve the feasibility of the placement scheme. The increase of the number of FTU configurations can effectively reduce the configuration of DULR by adding a small amount of μ PMU, reduce the total cost as a result. In future studies, we will further consider the integrated configuration of μ PMU, DULR and FTU, to meet more failure scenarios while reducing costs.

Measurement of improving the reliability of medium voltage power distribution system and its cost/benefit analysis

Research of Metering Scheme Key Techniques for Medium and Low Voltage DC Distribution Network

A Fuzzy-Based Evaluation Approach for Metering Schemes of Medium-Low Voltage DC Distribution Network

The Integrated Reliability Evaluation of Distribution System Considering the System Voltages Adjustment

Reliability-Based Planning of Medium-Voltage Power Distribution Systems and a Sensitivity Study of SAIDI to the Key Parameters

Design and Application of the Distribution Fault Assistant Analysis System

Reliability Assessment of Multiple-Voltage Regional Transmission and Distribution System Considering Substation Interior Failure

AN IMPROVED ALGORITHM OF FAULT LOCATION, ISOLATION AND RESTORATION FOR DISTRIBUTION SYSTEMS

Fault Location Method for Distribution Network Based on Synchronous Measurement

Fault Location Technology for Power System Based on Information About the Power Internet of Things

Accurate Fault Location Method of Distribution Network with Limited Number of PMUs

Joint optimal PMU and DULR placement in distribution network considering fault reconstruction and state estimation accuracy

Reliability Evaluation of Complex Distribution Network Based on Improved Network-Equivalent and Fault Influence Matrix

Analytical Method for Reliability Evaluation of Distribution System Considering Multiple Faults

The Quantitative Evaluation of Complex Distribution System Reliability

A Multi-fault Recovery Process Evaluation Method for Distribution System Considering Maintenance Strategy

Fault Locating and Severity Assessment for Power Distribution Systems Based on Elasticity Network Topology Mapping

Online Analysis and Assessment of Distribution Network Reliability Considering Load Levels and Power Supply Transferring at Different Period

Overall Voltage Level Reliability Assessment of Power System Based on Equivalent Model of Substations

Reliability evaluation method for distribution network with distributed generations considering feeder fault recovery and network reconfiguration

A Novel Approach for Distribution Fault Analysis