Analysis of Bending and Dynamic Behavior of Floating Hose

Bangjie Jin,Honglin Zhao,Qiang Gao,Dong Hu,Limei Xu,Zhongli Li

DOI: https://doi.org/10.16082/j.cnki.issn.1001-4578.2019.01.007

2019-01-01

Abstract:Few efforts have been put on the theoretical studies on floating hoses at sea in China, resulting in little theoretical basis for the design, manufacturing and maintenance of hose. To address the problem, the bending and dynamic behavior of floating hose are analyzed in depth. A finite element model of the floating hose was first established. When performing the bending behavior analysis, the position change of the point on the hose is recorded by applying an appropriate bending moment. The deflection of each section of the hose is then obtained, thereby attaining the bending rigidity and the equivalent elastic modulus of the hose. In the dynamic analysis of the hose, the hose is simplified to a beam to obtain the equivalent material parameters by an equivalent method. The Morison equation is then modified based on the floating state of the hose working condition to derive the wave load on the hose. Through the transient analysis, the loads of each part of the hose versus time are obtained. The analysis shows that, with the wave loads of multiple cycles are superimposed on each other, the deformation in the middle of the floating hose and the bending moment at the two ends have a complicated shape with time. Therefore, enhancement processing should be done at the two ends of the hose. The material at the intermediate position should have a relatively high tensile and bending capacity. The study results have an important reference for the design and manufacturing of floating hose.