Abstract:To perform maneuvers in a fly-by-wire aircraft, a pilot usually commands the yoke or the stick. This command is interpreted by a Flight control computer (FCC), which activates actuators of the control surfaces. To roll large aircraft, it is usual to employ ailerons and roll spoilers as control surfaces. The amount of deflection shared with each control surface is known as control allocation, and it is computed by flight control laws, algorithms embedded in the FCC. This work compares two methods of control allocation to roll aircraft, taking advantage of the flexibility given by fly-by-wire architecture, to compute adequate deflections of ailerons and roll spoilers that comply with requirements of performance, stability and handling qualities. Moreover, it presents alternatives to deal with possible nonlinearities of the roll spoilers. As a first method, it was considered a dead zone for roll spoilers, such that roll spoilers deflect only after certain deflection of ailerons. As a second method, it was considered that ailerons and roll spoilers work together whenever required. The study of the two methods covers real aspects for design in the whole flight envelope, in order to implement in a FCC: study of the bare-airframe (large-heavy transport/cargo aircraft adopted in this case), definition of objectives, control architecture, linear design, nonlinear integration and pilot-in-the-loop simulations. As result, pros and cons of each method are presented. In one hand, the first method is a conservative approach to deal with nonlinear behavior of roll spoilers around small deflections for example but can expose ailerons to rate saturation when deflecting alone in scenarios with poor control power. On the other hand, the second method alleviates the work of the ailerons, but it assumes a reliable model for design, which might be hard to develop. The results were validated with offline simulations and with pilots in a flight simulator.

A Yaw Control Method for Tailless Flying Wing Aircraft under Low Speed Condition

Adaptive Sliding Mode Control with Transition Process for Flapping Wing Aerial Vehicle

A Novel Control Allocation Method for Yaw Control of Tailless Aircraft

Trajectory Generation and Tracking Control for Flapping Wing Robot Three-Dimensional Flight

Control characteristics analysis of split-drag-rudder

Flight Control Algorithm For Small Uavs With Aerodynamic Asymmetry

An Innovative Experimental Approach to Lateral-Directional Flying Quality Investigation for Tailless Aircraft

Virtual flight test of pitch and roll attitude control based on circulation control of tailless flying wing aircraft without rudders

Control of Tailless Aircraft

Autonomous Flight Control Laws Design for a Tailless Flying-wing Unmanned Aerial Vehicle

Stability and Controller Research of Double-Wing FMAV System Based on Controllable Tail

A NEW X-ACTUATOR DESIGN FOR DUAL BENDING/TWISTING CONTROL OF WINGS

Analysis and Control for the Mode Transition of Tandem-Wing Aircraft with Variable Sweep

Longitudinal Attitude Control and Stability Analysis for a Low Aspect Ratio Flying Wing UAV at High Angle of Attack

Flight Controller Design and Demonstration of a Thrust-Vectored Tailsitter

Experimental Validation of an Effective Control Mechanism to Enable Flapping Wing Rotor Stable Flight

Minimum Snap Trajectory Generation and Control for an Under-actuated Flapping Wing Aerial Vehicle

Finite-time terminal sliding mode attitude control for tailless full-wing configuration UAVs based on extended state observers and auxiliary compensators

Fixed-time Adaptive Fuzzy Fault-Tolerant Attitude Control for Tailless Aircraft without Angular Velocity Measurements

Lateral control allocation using ailerons and roll spoilers for fly-by-wire aircraft

Dynamic Transition Corridors and Control Strategy of a Rotor-Blown-Wing Tail-Sitter