Abstract:Methanol is widely used as a potential alternative source for diesel fuel and can reduce the CO, THC and smoke emissions of the CI engines. However, the lower cetane number and energy content of methanol hinder the high substitution of methanol over diesel fuel. Introducing nanoparticles as fuel-additive is an effective approach to cope with this issue. In the present work, the alumina, ceria and silica nanoparticles were separately mixed into methanol in mass proportions of 25, 50 and 100 ppm with the composite surfactant of sodium dodecyl benzene sulfonate and cetyl trimethyl ammonium bromide (1:1 mass fraction) to create the nanofluid. The nanofluid was then injected into the intake port to combust synergistically with the mineral diesel fuel injected by the other high-pressure injection system, generating the nanoparticle-assisted methanol-diesel fuel mode (NMF). The characteristics of combustion and pollutant emission of NMFs were investigated with 10%, 30% and 50% methanol substituted level (M10, M30 and M50, respectively), at 10–90% engine loads of a constant engine speed. The results showed that the substitution of methanol led to an extension in the ignition delay but a shortening of combustion duration than diesel fuel. The additional introduction of alumina and ceria nanoparticles in each dosage, and silica nanoparticles in 100 ppm dosage, into M10 slightly shortened the ignition delay at 10% load conditions. When dosed into M50 fuel, all the three nanoparticles in various dosages led to shortened ignition delay at 10–50% engine loads. Over the test conditions, the addition of nanoparticles all caused a distinct increase in the peak in-cylinder pressure for the methanol-diesel dual-fuel mode. However, the addition of nanoparticles exerted marginal influences on further reduction of CO, HC and smoke emissions, and even further elevated the NOx emissions for MDF mode by up to 40%. Moreover, the deterioration degrees of NOx emissions for alumina and ceria nanoparticle addition were higher than the silica nanoparticles, and elevated towards the higher nanoparticle dosage and lower engine load.

Analysis the effects of adding Al2O3 and CeO2 nanoparticles to fuel on engine emission and vibration

The Effects of Adding TiO2 and CuO Nanoparticles to Fuel on Engine and Hand–Arm Driver Vibrations

Investigation on Thermal Properties of a Novel Fuel Blend and Its Diesel Engine Performance

Effect of Al2O3 Nanoparticles on Performance and Emission Characteristics of Diesel Engine Fuelled with Diesel–Neem Biodiesel Blends

Energy, exergy and sustainability analyses of nanoparticles added to fuels to reduce carbon footprint

Investigation of the environmental implications of using cerium oxide nano-additives in gasoline engines fueled with gasoline-oxyhydrogen

Impact of various metal-oxide based nanoparticles and biodiesel blends on the combustion, performance, emission, vibration and noise characteristics of a CI engine

Nanoparticles as fuel additive for improving performance and reducing exhaust emissions of internal combustion engines

Effect of Alumina and Bio‐Based Calcium Oxide Nanoadditives on Reduction of Emissions and Performance Improvement in a Common Rail Direct Injection Diesel Engine Fueled with B20 Blend of Waste Cooking Oil Biodiesel

Emission and performance analysis of diesel engine running with CeO2 nanoparticle additive blended into castor oil biodiesel as a substitute fuel

Discussion on the Combustion, Performance and Emissions of a Dual Fuel Diesel Engine Fuelled with Methanol-Based CeO2 Nanofluids

Comparison in the effects of alumina, ceria and silica nanoparticle additives on the combustion and emission characteristics of a modern methanol-diesel dual-fuel CI engine

Vibration, acoustic and emission characteristics of the chlorella vulgaris microalgae oil in compression ignition engine to mitigate environmental pollution

Utilization of Selected Nanoparticles (Ag2O and MnO2) for the Production of High-Quality and Environmental-Friendly Gasoline

Effect of different configurations of hybrid nano additives blended with biodiesel on CI engine performance and emissions

Experimental Investigation on Performance of a Compression Ignition Engine Fueled with Waste Cooking Oil Biodiesel–Diesel Blend Enhanced with Iron-Doped Cerium Oxide Nanoparticles

The effects of the usage of silicon dioxide (SiO2) and titanium dioxide (TiO2) as nano-sized fuel additives on the engine characteristics in diesel engines: a review

Optimizing engine performance and reducing emissions of greenhouse gases through spirulina microalgae and nano-additive blends

The Comprehensive Effects of Nano Additives on Biodiesel Engines—A Review

Optimization of diesel engine performance and emission characteristics with cerium oxide nanoparticles mixed waste cooking oil biodiesel blends

Effects of nano-additives and ammonia on performance and emission characteristics of diesel engine fueled with Aleurites moluccanus