Abstract:The three-dimensional model of a lightning rod under a thunderstorm simulated by COMSOL Multiphysics software is established in this paper to study the influencing factors on electric field distortion including the position, height and shape of the lightning rod. In the model, the thunderstorm cloud is equivalent to a plate capacitor; and the building, the lightning rod and the ground are regarded as perfect conductors; whereas their surface potential is zero. The electric field distortion coefficient K is used to measure the influencing parameters on the lightning attachment to the lightning rod. The analysis of model leads to the following conclusions: influenced by the electric field distortion, a lightning rod at a higher height or at the edge of the building is more likely stuck by the lightning. Considering the effects of the upward connecting leaders in the attachment process, we can further infer that the upward leaders usually start from the tip with greater distortion electric field in the attachment process. However, when the tip of the rod is too sharp, it is often accompanied by the fast attenuation of the electric field, which is not beneficial for the continuous development of the upward connecting leaders. Therefore, in the process of lightning protection design, it is necessary to consider both the position and the height, as well as the shape of the lightning rod in a comprehensive manner.

Influence of Lightning Current Waveform on Magnetic Fields in a Building Struck by Lightning

Distribution of Magnetic Field Inside the Buildings Directly Struck by Lightning

The Magnetic Field Distribution in Buildings with Separate Lightning Down Conductors During a Direct Lightning Stroke

Calculation of the Maximum Magnetic Field Inside the Lightning Protection System of a Building

CALCULATION OF TRANSIENT MAGNETIC FIELD INSIDE THE HIGH BUILDINGS STRUCK BY LIGHTNING

Effect of Grounding System on Electromagnetic Fields Around Building Struck by Lightning

Surge Current Distribution in a Reinforced Concrete Structure During Building Struck by Lightning

Experimental and Numerical Evaluation of Surge Current Distribution in Buildings During a Direct Lightning Stroke

Advanced Model of Space Charge Used for Simulation of Conductor under Lightning Strike

Influence of Lightning Monitoring Device Position on Measured Lightning Current Parameters

Simulation Calculation and Analysis of Lightning Induced Overvoltage on Power Distribution Lines

On the simulation of lightning current for the application in lightning arrester and material ablation tests

Electromagnetic Effect on Underground Pipeline of the Lightning Strike 330kV Transmission Lines

On the Lightning M-Component Electric Fields at Close Distances With Special Attention to Lightning Channel Inclinations

Simulation of Lightning Strike in 2-D & 3-D With Fractal Theory and Its Application

Lightning Striking Process Simulation and Its Effects

Analysis of the Influencing Factors of Electric Field Distortion Caused by the Lightning Rod

Analysis of the Electromagnetic Fields Inside Building Structure Using the Subgrid FDTD Method

Finite-element analysis about the influence of building on the atmospheric electric field measurements

Research on Lightning Current Shunting Characteristics Between Tower and Ground Wires Based on Field Test and Numerical Simulation

Time-Domain Simulation of Tower with Grounding Device under Lightning Strikes