Abstract:Cold spray additive manufacturing (CSAM) is relatively a new additive manufacturing technology that does not employ heat to achieve bonding between metal particles and the substrate. The CSAM process operates at a temperature lower than the melting temperature of the metal particle and the substrate. Hence, the constraints associated with high-temperature processing such as oxidation and phase change can be minimised, as well as the requirement of energy can be significantly reduced. This technology offers promising solutions for a wide range of applications in industries such as automotive, aerospace, and nuclear power generation. In this study, the effects of build orientation and post-build heat treatment on additively manufactured (AM) copper were investigated. Copper deposits were fabricated using a novel spraying system where stationary nozzle propels metal particles by compressed air onto a substrate clamped on a moving robot arm. The deposits were built in two different orientations (XY—0° and Z—90° to the build platform, respectively) and then mechanically tested in the as-deposited (AD), annealed at 400 °C (400 M), and sintered at 1000 °C (1000 M) conditions. The results strongly suggested that Z-build orientation samples had substantially lower inter-particle bonding strength compared with the XY-build direction samples due to the presence of porosity network. This pore network was created when the spray angle was abruptly changed from 90 to 45° orientation. The metallurgical bonding between particles improved with subsequent heat treatment. The 400 M samples consisted of recrystallised microstructure leading to an increase in tensile strength and ductility. Although the metallurgical bonding in the 1000 M samples was comparably better than the as-desposited samples, the formation of grossly large pores along grain boundaries acted as crack initiation sites, thereby resulting in very poor mechanical properties. This study has provided insights into the CSAM processing parameter selection and potential post-processing route to improve the mechanical properties of cold-sprayed copper parts.

Impact of Microstructural Anisotropy of As-Cold-Sprayed Cu Deposits on Its Annealing Effect

Evolution of Cold-Sprayed Copper Deposit Mechanical Properties as Function of Substrate Geometry and Heat Treatment Parameters

Relationship between particle interface structure and performance of cold sprayed CuCrZr deposit

Correlating Particle Impact Condition with Microstructure and Properties of the Cold-Sprayed Metallic Deposits

Effect of Parameters of Cold Sprayed Cu Particles on Its Impacting Behavior

The effect of annealing on trapped copper oxides in particle-particle interfaces of cold-sprayed Cu coatings

Effect of Interfacial Structure on Microstructure and Properties of Cold-Sprayed Cu-Al2O3 Composite Coating

A practical method to improve mechanical and electrical properties of ADS copper prepared by cold spray additive manufacturing through powder pretreatment

Microstructure Evolution of Cold-Sprayed Coating During Deposition and Through Post-Spraying Heat Treatment

Microstructure and Properties Tailoring of Cold Sprayed Metals

Influence of Feedstock in the Formation Mechanism of Cold-Sprayed Copper Coatings

Effect of Spray Angle on Deposition Characteristics in Cold Spraying

Improving Microstructure and Corrosion Resistance of Cold Spraying Cu Coating Through Annealing

The Influence of Spraying Parameters and Powder Sizes on the Microstructure and Mechanical Behavior of Cold-Sprayed Inconel®625 Deposits

Effects of different heat treatments on anisotropy of cold sprayed 7075 Al deposits

An induction heat treatment method for improving the mechanical properties and electrical conductivity of cold spray additive manufactured copper deposit

Comparative Analysis of Microstructural and Mechanical Attributes in Low-Pressure Cold-Spray Coatings: Impact of Varied Cu Feedstock Powders

Microstructure and Properties of Cu–Cr Coatings Deposited by Cold Spraying

Effect of build orientation and post-build heat treatment on the mechanical properties of cold spray additively manufactured copper parts

Effect of Heat Treatment on the Al-Cu Feedstock Powders for Cold Spray Deposition

A New Approach to Prepare Fully Dense Cu with High Conductivities and Anti-Corrosion Performance by Cold Spray